Makita 6019D Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 6019D. Makita 6019D 13 pagina's. 3/8" (10mm)
Ook voor Makita 6019D: Gebruiksaanwijzing (17 pagina's), Onderdelenlijst (2 pagina's)

Pagina afdrukken
Makita 6019D Gebruiksaanwijzing
FUNCTIONAL
DESCRIPTION
1. Set plate
2. Battery cartridge
1
1. Switch trigger
1
B
1. Reversing switch lever
2. Switch trigger
6
CAUTION:
•
Always be sure that the tool is switched off and the battery cartridge is
removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
002045
•
Always switch off the tool before insertion or removal of the battery
1
cartridge.
2
•
To remove the battery cartridge, pull out the set plate on the tool and
grasp both sides of the cartridge while withdrawing it from the tool.
•
To insert the battery cartridge, align the tongue on the battery cartridge
with the groove in the housing and slip it into place. Snap the set plate
back into place. Be sure to close the set plate fully before using the tool
to prevent the battery cartridge from accidentally falling out of the tool.
•
Do not use force when inserting the battery cartridge. If the cartridge
does not slide in easily, it is not being inserted correctly.
Switch action
002863
CAUTION:
•
Before inserting the battery cartridge into the tool, always check to see
that the switch trigger actuates properly and returns to the "OFF" position
when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop.
Reversing switch action
002071
This tool has a reversing switch to change the direction of rotation. Move the
reversing switch lever to the A side for clockwise rotation or the B side for
A
counterclockwise rotation.
When the reversing switch lever is in the neutral position, the switch trigger
cannot be pulled.
2
CAUTION:
•
Always check the direction of rotation before operation.
•
Use the reversing switch only after the tool comes to a complete stop.
Changing the direction of rotation before the tool stops may damage the
tool.
•
When not operating the tool, always set the reversing switch lever to the
neutral position.