HIKVISION 8 Series Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} HIKVISION 8 Series. HIKVISION 8 Series 18 pagina's.

2.3.2 Location Configuration Prevention

The following preventive measures assist you to design the proper environment for the

switch.

 Make sure that the workshop is well-ventilated, the heat of TX devices is

well-discharged and sufficient air circulation is provided for device cooling.

 Put the chassis at the place where cool air can blow off the heat inside the

chassis. Make sure the chassis is sealed because the opened chassis will

reverse the cool air flow.

The following content assists you to make a proper cabinet configuration:

 Each device on the cabinet gives off heat when it runs. Therefore, the sealed

cabinet must have the heat-discharge outlet and the cooling fan. Do not put the

devices too close, avoiding bad ventilation.

 When you install the chassis at the open cabinet, prevent the frame of the

cabinet from blocking the airway of the chassis.

 Ensure that nice ventilation is provided for the devices installed at the bottom of

the cabinet.

 The clapboard separates exhaust gas and inflow air, and boost the cool air to

flow in the chassis. The best location of the clapboard is decided by the air flow

mode in the chassis, which can be obtained through different location tests.

The tools and devices to install the 4/8 switch are not provided by the 4/8 switch. You

yourself need to prepare them. The following are the tools and devices needed for the typical

installation of the 4/8 switch:

 Screwdriver

 Static armguard

 Bolt

 Ethernet cable

 Other Ethernet terminal devices

 Control terminal

- 6 -