Gardena 9335-55 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gardena 9335-55. Gardena 9335-55 10 pagina's. Accu blower
Ook voor Gardena 9335-55: Gebruiksaanwijzing (18 pagina's)

Pagina afdrukken

For risks of injury do not use the battery as a power source for other products.

Only use the battery for the GARDENA product intended.

Only charge and use the battery in ambient temperatures of between 0 °C and

40 °C. Allow battery to cool down after long periods of use.

Check the charging cable regularly for signs of damage or ageing (brittleness).

Only use it in perfect condition.

Do not stow or transport the battery above 45 °C or in direct sunlight. Ideally, the

battery should be stored below 25 °C so that self-discharge is low.

Do not expose the battery to rain or wet conditions. Water entering a battery will

increase the risk of electric shock.

Keep battery in order (clean) especially air vents.

If usage of the battery is not planned for a certain time (winter period) reload the

battery to avoid a deep discharge.

Do not store while still attached to a tool, this prevents misuse and accidents.

Do not store the battery in places where static electricity is present.

Do not use the battery charger outdoors.

Protect battery from heat and fire.

DANGER! This product makes an electromagnetic field while it operates. This

field may under some conditions interfere with active or passive medical implants.

To decrease the risk of conditions that can possibly injure or kill, we recommend

persons with medical implants to speak with their physician and the medical

implant manufacturer before you operate the product.

DANGER! Small parts can be easily swallowed. There is also a risk that the poly-

bag can suffocate toddlers. Keep toddlers away when you assemble the product.

2. ASSEMBLY

Fitting the blower tube [ Fig. A1 ]:

DANGER! Risk of injury!

The motor must be stopped and the impeller blades no

longer turning to avoid serious injury from the rotating

blades.

v Stop the unit and remove battery before attempting to install

or remove the blower tube.

1. Align the grooves on the blower tube

outlet

2. Push the blower tube onto the blower outlet until it snaps into place;

tube is secured to blower by tube release button

3. To remove the blower tube, press the tube release button

pulling on tube.

3. INITIAL OPERATION

To charge the battery [ Fig. I1 / I2 / I3 ]:

CAUTION!

Overvoltage damages the battery and the battery charger.

v Make sure that you use the correct mains voltage.

For the GARDENA Accu Blower Art. 9335-55 there is no battery in

the scope of delivery.

Before you use the battery the first time, the battery must be completely

charged.

The lithium-ion battery can be charged in any state of charge and the

charging process can be disconnected at any time without to damage

the battery (no memory effect).

(A)

1. Push both locking buttons

and remove the battery

battery holder

(D)

2. Connect the battery charger

(C)

3. Connect the battery charger cable

When the charging control lamp

battery is being charged.

When the charging control lamp

the battery is completely charged

(charging time, see 8. TECHNICAL DATA).

4. Examine the charge status regularly while you charge.

(B)

5. When the battery

is completely charged, disconnect the battery

(C)

from the charger

(C)

6. Disconnect the charger

from the mains.

(B)

7. Slide the battery

onto the battery holder

audibly engages.

with the grooves on the blower

while

(B)

from the

into a mains socket.

(E)

(B)

to the battery

(Lc)

at the charger flashes green the

(Lc)

at the charger illuminates green

(D)

on the handle until it

Battery charging indicator [ Fig. I3 ]:

Battery charging indicator during charging:

100 % charged

66 – 99 % charged

33 – 65 % charged

0 – 32 % charged

Battery charging indicator during operation:

v Push the button

on the battery.

66 – 99 % charged

33 – 65 % charged

11 – 32 % charged

0 – 10 % charged

4. OPERATION

DANGER! Risk of injury!

Do not use the unit without the tube properly attached

to avoid flying debris and/or impeller contact which can

cause serious injury.

v Always wear gloves and use eye protection to prevent rocks

or debris from being blown or ricocheting into the eyes and

face which can result in blindness or serious injury.

Starting the blower [ Fig. O1 ]:

To start:

1. Push the battery onto the handle (see 3. INITIAL OPERATION).

2. Move the ON / OFF switch

To stop:

1. Move the ON/OFF switch

2. Remove the battery from the handle (see 3. INITIAL OPERATION).

Work positions [ Fig. O2 ]:

Use your unit as a blower for sweeping debris or grass clippings from

driveways, sidewalks, patios, etc. Also, for blowing grass clippings, straw,

or leaves into piles, or removing debris from corners, around joints, or

between bricks.

Direct air flow by directing the blower tube down or to one side.

Always work away from solid objects such as walks, large stones,

vehicles, and fences.

Clean corners by starting in corners and moving outward. This will help

prevent an accumulation of debris which could fly into your face. Be care-

ful when working near plants. The force of the air could damage tender

plants.

5. STORAGE

To put into storage [ Fig. A1 ]:

Store unit with battery removed, well out of the reach of children.

1. Stop unit and remove battery (see 3. INITIAL OPERATION).

2. Charge battery; this will increase the life of the battery.

3. Allow motor to cool before storing or transporting.

4. Store unit with all guards in place. Position unit so that any sharp object

cannot accidentally cause injury.

Overwintering:

Prepare unit for storage at the end of the season or if it will not be used for

30 days or more.

If your blower is to be stored for a period of time:

1. Stop unit and remove battery (see 3. INITIAL OPERATION).

2. Charge battery; this will increase the life of the battery.

3. Clean the entire unit before lengthy storage.

4. Use a soft brush to clean air vents and air inlet of debris.

Do not use water.

5. Store your unit in a well ventilated area and covered, if possible,

to prevent dust and dirt accumulation. Do not cover with plastic.

(B)

Plastic cannot breathe and may cause condensation and eventual

rust or corrosion.

6. Check entire unit for loose screws.

Replace any damaged, worn, or broken parts.

7. Remove blower tube for easier storage.

(L1)

(L2)

and

(L3)

illuminate (for 60 sec.)

(L1)

and

(L2)

illuminate,

(L3)

flashing

(L1)

(L2)

illuminates,

flashes

(L1)

flashes

(L1)

(L2)

and

(L3)

illuminate

(L1)

and

(L2)

illuminate

(L1)

illuminates

(L1)

flashes

to the ON (I) position.

to the OFF (0) position.