Alico Optima AP58 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Alico Optima AP58. Alico Optima AP58 12 pagina's. Wireless network equipment optima series
Ook voor Alico Optima AP58: Gebruiksaanwijzing (14 pagina's)

Pagina afdrukken
Scope:
This equipment is intended to be installed by professional trained installers familiar with the appropriate
FCC Regulations and Local Building Codes. The equipment is designed to be installed on a pole or as a
wall mount unit. While the unit is in operation the WNE antenna shall be at least 20 cms away from all
persons.

Setup Instructions:

Package Contains:
1.
AP24/58 Access Point-Bridge
2.
Power over Ethernet Injector
3.
48VDC Power Supply
4.
AC power cord
5.
RJ45 Feed-Through Assembly
6.
CD Containing the "WinBox" application software to provision the AP24/58 Access Point -
Bridge and a PDF version of this Instruction Manual.
What You Need to Get Started:
•
You need to provide 2 straight patch segments of CAT-5e Ethernet cable with RJ45 connectors
on each end. You may also need a crossover cable to configure the AP24/58 if you are connecting
directly to a PC.
•
The first CAT-5e patch cable will be used to connect the AP24/58 to the POE Injector module.
This cable needs to have RJ45 connectors preferably with no boots. Having a boot on the RJ45
cable on the AP24/58 side may prevent you to properly install the Feed-Through Assembly. See
instructions on the next slide.
•
CAUTION DO NOT USE A CROSS OVER CABLE BETWEEN THE AP24/58 AND THE
POE MODULE. YOU WILL PERMANENTLY DAMAGE THE AP24/58.
•
The second CAT-5e patch cable will be used to connect the POE module to your Switch/Router.
If you are connecting the POE module directly to your PC for setup you need to use a crossover
cable. The total length for both CAT-5e cable segments must not exceed 300 feet (~90 meters).
•
The options to setup the AP24/AP58 would be to connect your PC directly to the POE module
(using a crossover cable), through a switch (using a patch cable) or wireless. To connect using the
wireless interface set your PC/Laptop SSID to AP24 (or AP58) and click on connect. Once
connected you can follow the instructions shown on following pages using the WinBox.
•
The AP24/AP58 is shipped with a default private address 192.168.0.239. You can change this IP
address or setup multiple IP addresses for the AP.
•
In order to get started quickly the AP is shipped with an internal bridge setup (called "bridge1")
between the Wireless LAN Interface and the Ethernet Interface. This "bridge1 is setup with the
default IP address 192.168.0.239. You can also setup the unit in the router mode if needed to get
full routing, DHCP server, capabilities etc. The Wireless LAN is setup in the infrastructure AP
(AP-bridge) mode with a SSID of "AP24" (or AP58).
3