A&E Systems Electrolux AW300 Handleiding voor installatie en gebruik - Pagina 2

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} A&E Systems Electrolux AW300. A&E Systems Electrolux AW300 8 pagina's. Direct mounting case awning for mini-motorhomes, pick-up campers, vans, van conversions & pop-up tent trailers

Pagina afdrukken

ELECTROLUX AW AWNING

INSTALLATION / OPERATION

Application:

The Electrolux AW Case Awning is designed and intended for

direct mounting on straight and most curved mini-motor-

homes, pick-up campers, vans, van conversions and pop-up

tent trailers.

The optional Universal Van Adapter

allows permanent or temporary mounting to vans with rain

gutters without drilling holes in the van.

IMPORTANT: Read the entire installation procedure

before starting installation.

NOTE: The manufacturer assumes no liability for

damages or injuries resulting from installation or

operation of this product.

The manufacturer reserves the right to modify appearanc-

es and specifications without notice.

INSTALLATION

Tools Required:

Electric Drill

1/8"(3mm)

q Center Punch

FOR DIRECT WALL MOUNTING:

NOTE: When determining location for awning make

sure to consider door clearance if required and location

of vehicle components, etc.

SHEET METAL

SCREW

1. A.

Install C-Channel of awning Case into Awning Rail

by inserting C-Channel into one end of Awning Rail

and sliding awning Case into position (Fig. 1 A), or

by tilting Case up and inserting entire C-Channel

into Awning Rail and rotating Case down into posi-

tion. Fig. 1B.

Using the End Caps as templates, drill one 1/8" Dia.

hole into vehicle for each End Cap. Fig. 1A.

Secure each End Cap using one #10 x 3/4" Phillips

Pan Head Sheet Metal Screw with a small dab of

Silicone Sealant on each screw. Figs. 1A & 1 B.

Kit A&E

Part No. 939935

Necessary

only if Backing late is

needed)

1 B

1 0 x 3/4 PHILLIPS P

N HEA

SHEET METAL SCREW

NOTE: Be sure to use a dab of Silicone Sealant on every

screw where a hole has been drilled in the side of the

vehicle. This will prevent possible water leakage.

AWNING CASE

2. Using Wand, open awning Case by inserting Pin on end

of Wand into hole in Arm Assembly indicated by arrows

on bottom of Case. Fig. 2.

3. Lower Arm Assembly out of awning Case. Fig. 3.

4. A. Allow arm to hang freely from Case. Tighten Lock

Knob. Fig. 4A.

Repeat for other side.

Lower Arm Assembly to ground. With Foot still on

Inner

ground raise

ELECTROLUX AW

SIDE VIEW

Arm as high as it will go, Fig. 4B.