A&I Products A-C7481G Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} A&I Products A-C7481G. A&I Products A-C7481G 7 pagina's.

If the width of the ROPS is greater or less than 35" wide, the top and bottom brackets will be needed. These

brackets will allow adjustment to fit ROPS that are 27" to 40" in width. Use (6) 3/8" bolts and (6) 3/8" nuts

per bracket, two bolts and nuts are required for each slot. The orientation of the side mount plates will

depend on the angle of the ROPS.

Fig. 4

The side mount plates are reversible to accommodate forward and rear angled ROPS. The side mount plates

are slotted, this will allow adjustment to level the canopy once installed. The orientation of the side mount

plates is shown below (the curved edge will match the angle of the ROPS).

Fig. 2