ALIEN WELD XM IGBT Series Gebruikershandleiding - Pagina 17
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ALIEN WELD XM IGBT Series. ALIEN WELD XM IGBT Series 18 pagina's.
Pagina afdrukken
To make best use of the machine, daily checking is very important. During the daily checking, please check in the order of torch,
wire-feeding vehicle, all kinds of PCB, the gas hole, and so on. Remove the dust or replace some parts if necessary. To maintain the
purity of the machine, please use original welding parts.
Cautions： Only the qualified technicians are authorized to undertake the repair and check task of this welding equipment in case of
machine fault.
9.1. Power supply
Part
1. Operation, replacement and installation of Switch
Control panel
2.
Switch on the power, and check if the power indicator is on.
1.
Fan
Check if the fan is functioning and the sound generated is normal.
1.
Switch on the power supply, and check if abnormal vibration,
Power supply
heating of the case of this equipment, variation of colors of case
or buzz presents.
1.
Check if gas connection is available, case and other joints are in
Other parts
good connection.
9.2. Welding torch
Part
1.
Check if the nozzle is fixed firmly and
distortion of the tip exists.
Nozzle
2.
Check if there is spatter sticking on the
nozzle.
1.
Check if the contact tip is fixed firmly.
Contact tip
2.
Check if the contact tip is physically
complete.
1.
Make sure that there is the agreement of
wire and wire feed tube.
2.
Make sure that there is no bending or
elongation of wire feed tube.
Wire feeding
3. Make sure that there is no dust or spatter
hose
accumulated inside the wire feed tube,
which makes the wire feed tub blocked.
4. Check if the wire feed tube and O-shaped
seal ring
1. Make sure that the diffuser of
Diffuser
specification is installed and is unblocked.
9.DAILY CHECKING
Check
Check
are physically complete.
required
If the fan doesn't work or the
sound is abnormal, do inner
check.
Remarks
Possible gas leakage occurs due to the unfixed nozzle.
Spatter possibly leads to the damage of torch. Use
anti-spatter to eliminate the spatter.
Unfixed contract tip possibly leads to unstable arc.
The physically incomplete contact tip possibly leads to
unstable arc and arc automatically terminating.
Disagreement of the diameters of wire and wire feed tube
possibly leads to the unstable arc. Replace it/them if
necessary.
Bending and elongation of wire feed tube possibly leads to
the unstable wire feed and arc. Replace it if necessary.
If there is dust or spatter, remove it.
The Physically incomplete wire feed tube or O-shaped seal
ring possibly leads to the excessive spatter. Replace the wire
feed tube or O-shaped seal ring if necessary.
Defection weld or even the damage of torch occurs due to the
non-installation of diffuser or the unqualified diffuser.
Remarks
17