A&L Furniture Wingate Swingbed Montage-instructies - Pagina 3

Blader online of download pdf Montage-instructies voor {categorie_naam} A&L Furniture Wingate Swingbed. A&L Furniture Wingate Swingbed 3 pagina's.

STEP 3

Insert the eyebolts. (See photo 6.) Hook the chains to the eyebolts. (See photo 7.) Tip the swingbed back

and with someone to hold it for you, you can tighten all the arm bolts and eyebolts with flange nuts. (See

photos 8 & 9.)

If your swingbed came with ropes. See instructions below.

STEP 4

Attach the rope to the swingbed. Take a rope, put the end through the hole in the armrest, & through the

eyebolt below the arm. Pull on through the eyebolt & make a knot in the end of the rope. (See photos

below.) Attach another rope to the eyebolt in the back assembly the same way then repeat on other side.

The swingbed is now ready to hang. Hook the rings on hooks at the ceiling or if you purchased comfort

springs hook the rings on one end of the springs and hook the other end of the springs to the ceiling. The

two ropes on one side of the swing can hook on the same hook for hanging.

STEP 5

You will now need to adjust the ropes until the swingbed is at the desired height. The ropes are all fully

adjustable. To lower the swingbed push the bottom loops on the end of the rope further up the rope then

hold the top loops with one hand & pull the end of the rope up through the loops. To raise the swingbed pull

the rope through the loops in the opposite direction. The ropes attached to the front of the swingbed will

need to be adjusted to a different length than the ropes attached to the back. If the swingbed hangs

crooked adjust the ropes accordingly until it hangs properly.

How to make a knot:

photo 6

photo 8

photo 7

photo 9