A&S Studio Bar 100 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} A&S Studio Bar 100. A&S Studio Bar 100 14 pagina's.

Wall Mounting (if using option-B)

Note:

Installation must be carried out by qualified personnel only. Incorrect assembly can result in severe

personal injury and property damage (if you intend to install this product yourself, you must check

for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the

installer's responsibility to verify that the wall will safely support the total load of the unit and wall

brackets.

Additional tools (not included) are required for the installation.

Do not overtighten screws.

Keep this instruction manual for future reference.

Use an electronic stud finder to check the wall type before drilling and mounting.

1. Remove the backing paper from the rubber. Stick the rubber to the back of the soundbar.

NOTE: Ensure the surface is clean prior to sticking the rubber to the back of the soundbar.

2 Drill 2 parallel holes (Ø 3-8 mm each according to wall type) in the wall. The distance between the

holes should be 711 mm . Firmly fix 1 dowel into each hole in the wall if necessary.

3 Leave a 9 mm gap between the wall and the screw's head. Lift the soundbar over the heads of the

screws and slot into place.

Remove the protective cap of the OPTICAL

socket, then connect an OPTICAL cable

(included) to the TV's OPTICAL OUT socket

and the OPTICAL socket on the SoundBar.

•

The digital optical connector might be

labeled SPDIF or SPDIF OUT.

- 7 -

Dowel

Solid wall (i.e ., Solid brick,

Solid concrete , Solid wood,

Solid wooden battens)

Drywall, Plaster wall,

Lath wall, etc.

AC~