A&S 2.1 Bar with Wireless Subwoofer 300 Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} A&S 2.1 Bar with Wireless Subwoofer 300. A&S 2.1 Bar with Wireless Subwoofer 300 16 pagina's.
Pagina afdrukkenReplace the Remote Control Battery
-
The remote control requires a CR2025, 3V Lithium battery.
1 Push the tab on the side of the battery tray
towards the tray.
2 Now slide the battery tray out of the remote
control.
3 Remove the old battery. Place a new
CR2025 battery into the battery tray with
the correct polarity (+/-) as indicated.
4 Slide the battery tray back into the slot in
the remote control.
Precautions Concerning Batteries
•
When the Remote Control is not to be used for a long time (more than a month), remove the
battery from the Remote Control to prevent it from leaking.
•
If the batteries leak, wipe away the leakage inside the battery compartment and replace the
batteries with new ones.
•
Do not use any batteries other than those specified.
•
Do not heat or disassemble batteries.
Never throw them in fire or water.
•
Do not carry or store batteries with other metallic objects. Doing so could cause batteries to
short circuit, leak or explode.
•
Never recharge a battery unless it is confirmed to be a rechargeable type.
Placement and Installation
Placement
A If your TV is placed on a table, you can place the unit on the table directly in front of the TV
stand, centered with the TV screen.
B If your TV is attached to a wall, you can mount the unit on the wall directly below the TV screen.
Option - A
Wall Mounting (if using option-B)
Note:
-
Installation must be carried out by qualified personnel only. Incorrect assembly can result in
severe personal injury and property damage (if you intend to install this product yourself, you
must check for installations such as electrical wiring and plumbing that may be buried inside the
wall). It is the installer's responsibility to verify that the wall will safely support the total load of
the unit and wall brackets.
-
Additional tools (not included) are required for the installation.
-
Do not overtighten screws.
-
Keep this instruction manual for future reference.
-
Use an electronic stud finder to check the wall type before drilling and mounting.
Option - B
8