Align-Pilates C1-Pro Reformer Montagehandleiding - Pagina 3

Blader online of download pdf Montagehandleiding voor {categorie_naam} Align-Pilates C1-Pro Reformer. Align-Pilates C1-Pro Reformer 12 pagina's.

Pagina afdrukken

C1-Pro Reformer Map:

Standing

Platform

Footbar Selector

Jump Board

Fastener

2. Attaching the optional extension legs (optional extra)

If you have bought extension legs for your C1-Pro it is best to fit these first. We recommend getting a pair of stable

trestles to put the reformer on to enable easy fitting of the legs. Place the trestles 120cm apart and make sure the

top of the trestles have something soft on them to avoid scratching the reformer frame. Lift the reformer out of the

box and place it gently onto the trestles, so one of the trestles is underneath the point where the foot bar attaches to

the aluminium runner.

Remove the wheels at the foot end of the reformer, placing all nuts, bolts and washers to one side. Store the parts in

the order you removed them and then reinstall the wheels on to the higher legs. Remove all four of the black

adjustable screw in feet by unscrewing them completely out and then screw these completely in to the C1-Pro leg

extensions. For further information see the exploded diagram in Fig.1

below.

Using the allen bolts and a 6mm Allen key, screw in the 5 bolts per leg and hand tighten. Be careful not to

cross thread the bolts. Once all the bolts are in, tighten fully with the Allen key.

After removing your trestles or other elevation device, put your reformer down where you intend to use it.

Then use a spirit level to check the reformer is level and stable. Adjust the level of the reformer by turning

the rubber feet in or out. Tip: Always lower a high foot before raising a low foot.

Maintenance: Periodically check all bolts that attach the legs to the reformer are tight. For further

information on maintenance please see point 10.

3. Insert the Reformer Carriage

With the reformer back on the floor, carefully remove the carriage from its packaging. With one person

holding each side of the carriage gently slide the carriage in to the runners with the springs pointing to-

wards the standing platform. Be very careful not to damage the wheels when sliding in to the runners.

Removable Shoulder Rests

Footbar

Carriage Bed

Rope Holder

Silent Straps & Ropes

Adjustable Feet

Ref

Code

Name

Left leg standing platform end

Right leg standing platform end

Right leg rope riser end

Left leg rope riser end

Flat washer

Spring washer

Bolt

Adjustment Knob

End Stopper

Rope Pulley

Specification

8.5*20*T1.5

8.3*12.7*T2.0

M8*20

Rope Riser

Fig.1

Qty