Alinco 235T Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Alinco 235T. Alinco 235T 6 pagina's. Vhf/uhf radios

Alinco 235T Gebruikershandleiding
important to know how to terminate a function selection. On the Alinco, you push the V/M
function key to terminate or close function selection.
SIMPLEX OPERATION: Simplex is the simplest mode of operation. Simplex does not
involve a repeater and is used to communicate with a "near by" ham who is approximately in
your line of sight. Line of sight could be several miles away if you are standing on top of a hill,
or less than a half mile if you are surrounded by hills, buildings or other obstructions.
To operate simplex you tune the radio to the frequency that you and the ham that you want to
talk to agree upon. In addition, you have to turn off the radio's repeater frequency shift
function. Frequency shift is utilized only when communicating through a repeater. It is not
used for simplex operation. Finally, set the radio's output power to an appropriate level (usually
low or medium power), set the squelch control to eliminate background noise, and turn the
volume control to a comfortable listening level. You are now ready to begin simplex
communications. These steps are described in more detail below
Frequency Selection: Radios have two operating modes, VFO mode and memory mode. To set
the radio to the correct frequency you must be in the VFO mode. If the radio is in the memory
mode, an M will appear on the left edge of the display. If you are in the memory mode, the
V/M function key must be pushed to enter the VFO mode (the M will disappear from the
display).
The Variable Frequency Oscillator (VFO) is the module that controls the radio's frequency.
Turning the Tuning Knob causes the radio to change frequency in very small steps. If the
person that you want to talk to is on a frequency of 147.555 MHz and the radio is tuned to
144.000 MHz, it will take you all day to "crank" the Tuning Knob to a frequency of 147.555
MHz. To move across the band quickly push the MHz function key. The display will change to
144. Turn the Tuning Knob 3 clicks. The frequency display will change from 144 to 145, then
146, and finally 147. Pushing the MHz key again puts the radio back in the normal mode. Now
turn the Tuning Knob until you reach 147.555 MHz.
Turn Off Shift: When communicating through a repeater, the frequency that you are listening
to (the repeater output frequency) will be automatically changed (shifted) by the radio to the
repeater input frequency when you begin to transmit. In simplex mode you do not want this to
happen. In simplex mode, the frequency that you are listening to is also the frequency that you
want to transmit on. To ensure that this happens, you must turn off the shift function. Notice
that the word SHIFT is displayed above the MHz function key. Since SHIFT is written above
the key, it means that you activate the Shift function by first pushing the Function (FUNC) key
and then the MHz key. Repeating this two keystroke operation will cycle you through three
options, minus shift (a – appears at the top of the display), plus shift (a + appears at the top of
the display), no shift (neither a + nor – symbol appears at the top of the display). It is this last
option (no shift) that you want for simplex operation.
Power Level: The Alinco radio has three transmit power levels, High, Medium, and Low. To
minimize interference to others and to minimize the drain on your power supply or batteries, set