Garmin ZUMO 396 LMT-S Europe Gebruikershandleiding - Pagina 27
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garmin ZUMO 396 LMT-S Europe. Garmin ZUMO 396 LMT-S Europe 32 pagina's.
Pagina afdrukken
6
When your zūmo device prompts you to enter file transfer
mode, select Yes.
7
On your computer, click Add a Device.
The Garmin Express software detects your device.
8
Click Add Device.
9
Follow the on-screen instructions to register your device and
add it to the Garmin Express software.
When setup is complete, the Garmin Express software
searches for map and software updates for your device.
10
Select an option:
• To install all available updates, click Install All.
• To install a single update, click View Details and select an
update.
NOTE: if a map update is too large for the internal storage of
the device, the software may prompt you to install a microSD
card in your device to add storage space
memory card for maps and data, page
The Garmin Express software downloads and installs the
updates onto your device. Map updates are very large, and this
process may take a long time on slower Internet connections.
Device Care
Avoid dropping your device.
Do not store the device where prolonged exposure to extreme
temperatures can occur, as it can cause permanent damage.
Never use a hard or sharp object to operate the touchscreen as
this may result in damage.
Cleaning the outer casing
Avoid chemical cleaners and solvents that can damage plastic
components.
1
Clean the outer casing of the device (not the touchscreen)
using a cloth dampened with a mild detergent solution.
2
Wipe the device dry.
Cleaning the Touchscreen
1
Use a soft, clean, lint-free cloth.
2
If necessary, lightly dampen the cloth with water.
3
If using a dampened cloth, turn off the device and disconnect
the device from the power.
4
Gently wipe the screen with the cloth.
Avoiding theft
• Remove the device and mount from sight when not in use.
• Remove the residue left on the windscreen by the suction
cup.
• Do not keep your unit in the glove compartment.
• Register your device using the Garmin Express software
(garmin.com/express).
Troubleshooting
(Installing a
24).
NOTICE
NOTICE
Resetting the device
You can reset your device if it stops functioning.
Hold the power key for 12 seconds.
Removing the Device, Mount and Suction
Cup
Removing the Device from the Mount
1
Press the release tab or button on the mount.
2
Tilt the bottom of the device upward, and lift the device from
the mount.
Removing the Mount from the Suction Cup
1
Turn the device mount to the right or left.
2
Apply pressure until the socket on the mount releases the
ball on the suction cup.
Removing the Suction Cup from the Windscreen
1
Flip the lever on the suction cup towards you.
2
Pull the tab on the suction cup towards you.
Changing the Fuse in the Vehicle Power
Cable
When replacing the fuse, do not lose any of the small pieces
and make sure they are put back in the proper position. The
vehicle power cable does not work unless it is assembled
correctly.
If your device does not charge in your vehicle, you may need to
replace the fuse located at the tip of the vehicle adapter.
1
Rotate the end piece
TIP: you may need to use a coin to remove the end piece.
2
Remove the end piece, the silver tip
3
Insert a new fast-blow fuse that has the same current, such
as 1 A or 2 A.
4
Place the silver tip in the end piece.
5
Push in the end piece and rotate it clockwise to lock it back
into the vehicle power cable
Troubleshooting
The suction cup will not stay on my
windscreen
1
Clean the suction cup and windscreen with surgical spirit.
2
Dry with a clean, dry cloth.
3
Mount the suction cup
(Mounting Your Device in an
Automobile, page
2).
My device is not acquiring satellite signals
• Verify the GPS simulator is turned off
page
20).
• Take your device out of multi-storey car parks and away from
tall buildings and trees.
• Remain stationary for several minutes.
NOTICE
anti-clockwise to unlock it.
, and the fuse
.
(Navigation settings,
.
23