Garmin Vivofit Gebruikershandleiding - Pagina 4
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garmin Vivofit. Garmin Vivofit 6 pagina's. Fitness bracelet
Ook voor Garmin Vivofit: Gebruikershandleiding (4 pagina's), Gebruikershandleiding (8 pagina's), Beknopte handleiding (25 pagina's)
Pagina afdrukken
*The device withstands pressure equivalent to a depth of 10 m.
For more information, go to www.garmin.com/waterrating.
User Replaceable Batteries
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Replacing the vívofit Device Batteries
Before you can replace the device batteries, you must obtain
two CR1632 batteries.
1
Remove the module from the band.
2
Use a small Phillips screwdriver to remove the four screws on
the front of the module.
3
Remove the cover and batteries.
4
Apply a small amount of petroleum jelly to each side of the
new batteries using a cotton swab.
5
Insert the new batteries.
NOTE: Do not damage or lose the gasket.
6
Replace the front cover and the four screws.
7
Tighten the four screws equally and firmly.
8
Insert the module into the band.
The device key on the module must be aligned with the key
on the band.
4
WARNING
Replacing the Heart Rate Monitor Battery
1
Locate the circular battery cover on the back of the heart rate
monitor.
2
Use a coin to twist the cover counter-clockwise until it is
loose enough to remove (the arrow points to OPEN).
3
Remove the cover and the battery.
4
Wait 30 seconds.
5
Insert the new battery with the positive side facing up.
NOTE: Do not damage or lose the O-ring gasket.
6
Use a coin to twist the cover clockwise back into place (the
arrow points to CLOSE).
After you replace the heart rate monitor battery, you may need
to pair the heart rate monitor with the device again.
Device Care
Avoid extreme shock and harsh treatment, because it can
degrade the life of the product.
Avoid pressing the keys under water.
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that can
damage plastic components and finishes.
Thoroughly rinse the device with fresh water after exposure to
chlorine, salt water, sunscreen, cosmetics, alcohol, or other
harsh chemicals. Prolonged exposure to these substances can
damage the case.
Do not place in high temperature environments, such as a
clothes dryer.
Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.
Cleaning the Device
1
Wipe the device using a cloth dampened with a mild
detergent solution.
2
Wipe it dry.
Caring for the Heart Rate Monitor
A build up of sweat and salt on the strap can decrease the ability
of the heart rate monitor to report accurate data.
• Rinse the strap after every use.
• Hand wash the strap occasionally, using a tiny amount of
mild detergent, such as dishwashing liquid.
NOTE: Using too much detergent may damage the strap.
• Do not put the strap in a dryer.
• When drying the strap, hang it up or lay it flat.
Troubleshooting
My device won't turn on
If your device no longer turns on, you may need to replace the
batteries.
Go to
Replacing the vívofit Device Batteries, page
NOTICE
NOTICE
4.
vívofit Owner's Manual