Brother 888-N02 Bedieningshandleiding - Pagina 8

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Brother 888-N02. Brother 888-N02 32 pagina's.
Ook voor Brother 888-N02: Bedieningshandleiding (32 pagina's)

Pagina afdrukken

Pass the thread under the thread guide and

around the pretension disk, front to back�

Pretension disk

Passing the thread through a hole on the bobbin,

set the bobbin on the bobbin winder shaft, and

then slide the shaft to the right�

Make sure the notch fits the projection�

Projection

Memo

• Checking the orientation of the bobbin will

be helpful in later procedures� By placing

the bobbin into the bobbin case in the same

orientation that it was on the bobbin winder

shaft, the bobbin can be installed with the

correct winding direction of the bobbin thread�

The "b" mark on one side of the bobbin

included with this machine can be used as a

reference�

Turn on the machine�

While holding the end of the thread, start the

machine to wind the thread around the bobbin a

few times�

7-8 cm

Notch

Bobbin winder shaft

Bobbin case

OFF

Depress

gently�

Stop the machine and trim the excess thread�

Release�

Slide the sewing speed controller to adjust the

bobbin winding speed� ★

Slower

Start the machine�

Depress�

Note

• We recommend winding stretch thread, such as

transparent nylon thread, at a low speed since

the thread may stretch�

When the bobbin seems full and

begins spinning slowly, stop the

machine�

Cut the thread, slide the bobbin winder shaft to

the left and remove the bobbin�

CAUTION

• Make sure you follow the instructions

carefully� If you do not cut the thread

completely and the bobbin is wound, when

the thread runs low, it may tangle around the

bobbin and cause the needle to break�

• Not winding the bobbin

properly may cause the

thread tension to loosen,

and may break the needle�

Raise the needle to its highest position, and then

raise the presser foot lever�

Turn toward you�

Turn off the machine�

★

Open the bobbin cover�

★

Faster

★

: Only for some models�