Garmin Fishfinder 240 Blue Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garmin Fishfinder 240 Blue. Garmin Fishfinder 240 Blue 50 pagina's. Garmin fishfinder 160 blue owner's manual
Ook voor Garmin Fishfinder 240 Blue: Gebruikershandleiding (50 pagina's), Handleiding voor piloten (12 pagina's), Specificaties (2 pagina's), Specificaties (2 pagina's), Gebruikershandleiding (50 pagina's), Gebruikershandleiding (50 pagina's)

Wiring Harness Installation

The Fishfinder 160 comes with a wiring harness that connects the unit

to power and the transducer with one easy-to-remove connection. Make

sure the wiring harness will reach the unit before beginning installation.

If it is necessary to extend the power/data wires, use a wire of compa-

rable size and keep your extension as short as possible.

If the transducer lead is too short, DO NOT cut the transducer lead

to lengthen the cable. This will void the warranty. Transducer extension

cables are available in 10' or 20' lengths from your GARMIN dealer.

If your boat has an electrical system, it may be possible to wire the unit

directly to an unused holder on your current fuse block. If you are using the

boat' s fuse block, remove the in-line fuse holder supplied with the unit.

Installing the Wiring Harness:

1. Determine the polarity of the fuse holder using a Test Light or Volt Meter.

2. Install the Red (+) wire on the Positive Fuse Holder Terminal.

3. Install the Black (-) wire on the Negative Fuse Holder Terminal.

4. Install a 2 amp fuse in the Fuse Holder.

During a typical installation, only the Red and Black wires are used. The

Blue wire supplies NMEA data, and doesn't have to be connected for normal

operation of the unit. The Yellow (alarm) wire is not used, the Fishﬁ nder 160

does not support external alarms.

Installing the Wiring Harness

Install 2-Amp Fuse

Continued on page 6

Installation

10-18 Volt Boat Supply

Boat Ground

Fishﬁ nder 160