Garmin GHP 10 Marine Autopilot System Handleiding voor installatie-instructies - Pagina 7

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Garmin GHP 10 Marine Autopilot System. Garmin GHP 10 Marine Autopilot System 26 pagina's. Tachometer reference
Ook voor Garmin GHP 10 Marine Autopilot System: Snelstarthandleiding (21 pagina's), Handleiding voor installatie-instructies (48 pagina's), Technische referentie (42 pagina's), Conformiteitsverklaring (1 pagina's), Referentie (1 pagina's)

Garmin GHP 10  Marine Autopilot System Handleiding voor installatie-instructies
General Connections Diagram
Refer to this diagram for component-interconnection reference only. Follow the detailed installation instructions for each component.
Item Description
GHC 10
GHC 10 data cable
NMEA 2000 power cable
NMEA 2000 network
CCU
Boat Tachometer
ECU
ECU power cable
CCU/ECU interconnect cable In order for the autopilot to turn on, the yellow wire from this cable must be connected to the yellow wire from
GHP 10 Installation Instructions
POWER
DRIVE
CCU
FEEDBACK
GHP 10 General Connection outline
Important Considerations
In order for the autopilot to turn on, the yellow wire from this cable must be connected to the yellow wire from
the CCU/ECU interconnect cable, and the black wire from this cable must be connected to the same ground
as the ECU
(page
12).
This cable should be installed only if you are building a NMEA 2000 network. Do not install this cable if there is
an existing NMEA 2000 network on your boat
The NMEA 2000 power cable must be connected to a 9–16 Vdc power source.
The GHC 10 and the CCU must be connected to the NMEA 2000 network using the included T-connectors
(page
12).
If there is not an existing NMEA 2000 network on your boat, you can build one using the supplied cables and
connectors
(page
13).
Mount the CCU with the cables pointing straight down
For tachometer connection, see
The ECU can be mounted in any orientation.
The ECU can be connected to a 12–24 Vdc power source. To extend this cable, use the correct wire gauge
(page
10).
The black wire from the GHC 10 data cable must be connect to the same ground as this cable
the GHC 10 data cable.
To extend this cable to reach the ECU, purchase the necessary extensions
The red and blue wires from this cable must be connected to the alarm
(page
13).
(page
10).
page
11.
}
(page
(page
4).
(page
11).
12).
7