Garmin GPSMAP 2010 Installatiehandleiding - Pagina 4

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Garmin GPSMAP 2010. Garmin GPSMAP 2010 8 pagina's. Garmin gsd 20 marine-remote sounder: release note
Ook voor Garmin GPSMAP 2010: Handleiding voor installatie-instructies (12 pagina's), Conformiteitsverklaring (1 pagina's), Conformiteitsverklaring (1 pagina's), Gebruikershandleiding (20 pagina's)

GPSMAP 2006 / 2010 / GPS 17N Installation Guide

Installing the GPS 17N

The GPS 17N installs on any standard 1" OD Marine Mount. The cable can be

run externally or if possible, through the center of the mount. The GPS 17N con-

nects to the 18-pin Power/Data Cable on the GPSMAP 2006/2010 and provides the

GPS signal for the unit.

The antenna should be mounted in a location that has a clear, unobstructed view

of the sky in all directions to ensure the best reception. Avoid mounting the antenna

where it will be shaded by the boat' s superstructure, a radome antenna, or mast.

Sailboat users should avoid mounting the antenna high on the mast to prevent inac-

curate speed readings caused by excessive heeling. The unit will provide more stable

readings if it is located nearer to water level. Most marine VHF and LORAN antennas

should not seriously degrade the GPS antenna' s reception. It is recommended that

the antenna be mounted at least 3 ft. away from (preferably above) the path

of any radar beam. If interference is experienced, relocate the antennas further

apart. Never paint the GPS antenna or clean it with harsh solvents.

Mounting the GPS 17N with cable outside mount:

1. Place the cable in the vertical slot along the side of the base of the unit.

2. Screw the GPS 17N onto the mount. Make sure that you do not overtighten the

head. It is possible to tighten the unit to the point that the cable may be cut in two.

3. With the GPS 17N and mount installed, ﬁ ll the remaining gap in the cable exit on

the with a marine sealant.

4. When running the cable, attempt to keep the cable away from sources of electronic

interference.

Mounting the GPS 17N with cable through mount:

1. Position the mount in the desired location and mark the approximate center of the

mount

2. Drill a hole large enough for the cable to pass through at the marked location.

3. Slide the cable through the mount and screw the GPS 17N onto the mount.

4. Fasten the mount to the boat

5. When running the cable, attempt to keep the cable away from sources of electronic

interference.

GPS 17N with cable run internally

Three common sources of interference for GPS signals are:

ABOVE- OK

Radar

BELOW- OK

Radar

EMI

EMI (Electromagnetic Interference) from

engine components

GPS 17N

GPS 17N with cable run externally

VHF Radio Antenna