Garmin GPSMAP 3005C Handleiding voor installatie-instructies - Pagina 4
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Garmin GPSMAP 3005C. Garmin GPSMAP 3005C 10 pagina's. Declaration of conformity
Ook voor Garmin GPSMAP 3005C: Snelle referentiehandleiding (2 pagina's), Sjabloonhandleiding (1 pagina's), Snelle referentie (2 pagina's), Handleiding voor installatie-instructies (17 pagina's), Conformiteitsverklaring (1 pagina's)
Pagina afdrukken
•
The GPS 17x antenna provides more-stable readings when located nearer to water level.
Mount the GPS 17x antenna at least 3 ft. (1 m) away from (preferably above) the path
•
of any radar beam or a VHF radio antenna.
•
Temporarily secure the antenna in the preferred mounting location and test it for correct
operation. If you experience interference with other electronics, try a different location.
When you verify correct operation, permanently mount the antenna.
Surface-mounting the GPS 17x Antenna
1. Use the surface-mount bracket as your mounting template
•
Use the center punch to mark the three screw locations on the surface.
•
Use a pencil to trace the cable hole in the center of the bracket.
•
Set the surface-mount bracket aside. Do not drill through the surface-mount bracket.
/
in. (3 mm) pilot holes
2. Drill the three
1
8
NotE: If you are mounting the GPS 17x on fiberglass, it is recommended to use a countersink bit to drill a clearance counterbore through the top
gelcoat layer (but no deeper). This will help to avoid cracking in the gelcoat layer when the screws are tightened.
3. Use a 1 in. (25 mm) hole saw to cut the cable hole in the center.
4. Place the seal pad on the bottom of the surface-mount bracket. Make sure that the screw
holes align.
5. Use the included M4 screws to attach the surface-mount bracket to the mounting
surface.
6. Route the GPS 17x cable through the 1 in. cable hole and connect it to the
GPS 17x.
7. Make sure the large gasket is in place on the bottom of the GPS 17x antenna, place
the antenna on the surface-mount bracket
place
➋
.
8. Secure the antenna to the mounting bracket with the included M3 set screw
9. Route the GPS 17x cable away from sources of electronic interference, and
connect it to power and to your GPSMAP 3000 series chartplotter (Page 6).
Pole Mounting the GPS 17x Antenna
With the pole-mount adapter attached to the GPS 17x, you can install the GPS 17x on a
standard 1 in. OD pipe-threaded-pole marine mount (14 threads per inch—not included). You can run the GPS 17x cable through the pole or
outside the pole.
To mount the GPS 17x with the cable run outside the pole:
1. Route the GPS 17x drop cable through the pole-mount adapter, and place the cable in the vertical slot along the base of the pole-mount
adapter.
2. Thread the pole-mount adapter onto a standard 1 in. OD pipe-threaded-pole marine mount
(14 threads per inch—not included). Do not overtighten the adapter.
3. Connect the GPS 17x cable to the GPS 17x antenna.
4. Place the GPS 17x antenna on the pole-mount adapter
5. Secure the antenna to the adapter with the included M3 set screw
6. (Optional) With the GPS 17x installed on the pole mount, fill the remaining gap in the vertical cable
slot with a marine sealant.
7. Attach the marine mount to the boat if it is not already attached.
8. Route the GPS 17x cable away from sources of electronic interference, and connect it to power
and to your GPSMAP 3000 series chartplotter (Page 6).
To mount the GPS 17x with the cable run through the pole:
1. Position a standard 1 in. OD pipe-threaded-pole marine mount (14 threads per inch—not included)
in the preferred location, and mark the approximate center of the pole.
2. Drill a hole using a
/
in. (19 mm) drill bit for the cable to pass through.
3
4
3. Fasten the marine mount to the boat.
.
➊
, and twist it clockwise to lock it in
and twist it clockwise to lock it in place
➊
Surface-mount
Surface-mount
bracket
bracket
.
➌
Seal pad
Seal pad
Mounting
Mounting
surface
surface
.
➌
Better
Better
EMI
EMI
EMI (Electromagnetic Interference)
EMI (Electromagnetic Interference)
from engine components
from engine components
Above - best
Above - best
Below - OK
Below - OK
Radar
Radar
VHF Radio Antenna
VHF Radio Antenna
GPS 17x Placement Considerations
GPS 17x Placement Considerations
➊
➊
➌
➌
.
➋
➊
➊
Pole-mount
Pole-mount
adapter
adapter
Vertical cable
Vertical cable
slot
slot
GPSMAP 3000 Series Installation Instructions
Best
Best
Good
Good
3 ft.
3 ft.
(1 m)
(1 m)
➋
➋
GPS 17x
GPS 17x
antenna
antenna
➌
➌
Rubber
Rubber
gasket
gasket
➋
➋
GPS 17x
GPS 17x
antenna
antenna