Garmin GPSMAP 4010 Technische referentie - Pagina 40

Blader online of download pdf Technische referentie voor {categorie_naam} Garmin GPSMAP 4010. Garmin GPSMAP 4010 42 pagina's. Weather and xm satellite radio gpsmap 4000 series; gpsmap 5000 series; gpsmap 6000 series; gpsmap 7000 series
Ook voor Garmin GPSMAP 4010: Handleiding voor installatie-instructies (25 pagina's), Handleiding voor installatie-instructies (25 pagina's), Snelle referentiehandleiding (2 pagina's), Belangrijke veiligheidsinformatie (48 pagina's), Conformiteitsverklaring (1 pagina's), Belangrijke informatie (2 pagina's), Supplement handleiding (24 pagina's)

Garmin GPSMAP 4010 Technische referentie
NMEA 2000 Checklist
Intelliducer (Intelligent Depth Transducer–Transom Mount and Thru-Hull)
Setting the Keel Offset
Adjust the Keel offset to display a depth reading from the water line or from the lowest point of the boat (keel) rather than the actual location
of the Intelliducer.
To adjust the keel offset:
1. While viewing the NMEA 2000 device configuration menu, select a specific Intelliducer and select
2. Enter the measured distance from the Intelliducer location to the water line or to the keel of the boat.
If you are measuring down to the keel (Intelliducer installed at the water line), enter a (+) positive number.
If you are measuring up to the water line (Intelliducer installed on the keel), enter a (-) negative number.

GWS 10 (Garmin Wind Sensor)

Configuring the Wind Angle Offset (Orientation)
When mounting the sensor, you must adjust the angle offset if you did not orient the GWS 10 as described in the GWS 10 Installation
Instructions.
To configure the wind angle offset (orientation):
1. While viewing the NMEA 2000 device information, select
2. Select the angle in degrees to adjust for the difference in orientation.
tiP: The angles are configured clockwise around the mast of the boat. For example, 90 degrees is on the starboard side of the boat, and 270 degrees is
on the port side.
Configuring the Wind Speed Filter
The wind speed filter governs how quickly the NMEA 2000-compatible display device shows a change in the wind speed. A lower filter setting
shows changes in the wind speed more gradually, and may stabilize the display.
To configure the wind speed filter:
1. While viewing the NMEA 2000 device information, select
2. Choose from the following options to adjust the filter settings.
Off—the wind speed data is not filtered.
On—select a lower number to show a change in the wind speed more gradually, and help the gauge needle or wind speed number to
move or change more steadily.
Auto—automatically adjusts the filter settings based on wind conditions.
6
Intelliducer at the water line
Enter a (+) positive number
to show depth at the
bottom of the keel.
Intelliducer at the bottom
of the keel
Enter a (-) negative
number to show depth at
the surface.
Config
Config
Keel Offset
>
Wind Angle
Offset.
>
Wind Speed
Filter.
Config
>
Keel
Offset.
Technical Reference for Garmin NMEA 2000 Products