Garmin GPSMAP 500 Series Handleiding voor piloten - Pagina 22

Blader online of download pdf Handleiding voor piloten voor {categorie_naam} Garmin GPSMAP 500 Series. Garmin GPSMAP 500 Series 28 pagina's. Flat-mount kit
Ook voor Garmin GPSMAP 500 Series: Gebruiksaanwijzing (6 pagina's), Handleiding voor piloten Addendum (27 pagina's), Snelle referentiehandleiding (2 pagina's), Referentiehandleiding (2 pagina's), Gebruiksaanwijzing (28 pagina's), Sjabloon (2 pagina's), Sjabloon (1 pagina's), Configuratiehandleiding (2 pagina's), Snelstarthandleiding (4 pagina's), Gebruikershandleiding (38 pagina's), Gebruikershandleiding (44 pagina's), Handleiding voor installatie-instructies (34 pagina's), Snelle referentiehandleiding (2 pagina's)

Pagina afdrukken
Garmin GPSMAP 500 Series Handleiding voor piloten
SECTION 4
RYAN TCAD INTERFACE
Configuring TCAD Data on the Map Page
The display of traffic information closely resembles the
display symbology used by the Ryan TCAD. Traffic data
is only displayed on the Map Page if heading data is
available.
Configuring Traffic on the Map Page:
Turn the small right knob to select the Map
1)
Page.
Press the MENU Key to display the Page
2)
Menu.
3)
Use the small right knob to select 'Setup
Map?'
Press the ENT Key. The flashing cursor
4)
highlights the GROUP field.
5)
Turn the small right knob to select 'Traffic'
(Figure 4-2).
Figure 4-2 Map Setup Options Menu
Press the ENT Key.
7)
Turn the large right knob to select the desired
8)
Traffic Mode option.
Turn the small right knob to select the desired
9)
option.
10) Press the ENT Key. Repeat steps 8-10 for Traffic
Symbol and Traffic Label.
11) Press the CLR Key to return to the Map Page.
4-2
Displaying Thumbnail Traffic onthe Map Page
The Map Page has the ability to display traffic in a
thumbnail format in any of the top three fields (top four
fields on a 500 Series unit) on the right-hand side of the
Map Page.
To display Thumbnail Traffic on the Map
Page:
Turn the small right knob to select the Map
1)
Page.
2)
Press the MENU Key to display the Page
Menu.
Use the small right knob to select 'Change
3)
Fields?' (Figure 4-3).
4)
Press the ENT Key.
5)
Turn the large right knob to select one of the
top three fields (top four fields on a 500 Series
unit).
6)
Select 'TRFC' from the Select Field Type List.
7)
Press the ENT Key.
NOTE: The thumbnail range defaults to 6 nm and
cannot be changed.
400/500 Series Display Interfaces
Figure 4-3 Map Page Menu
190-00140-10 Rev. E