Garmin Colorado 400c Gebruikershandleiding - Pagina 29

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garmin Colorado 400c. Garmin Colorado 400c 40 pagina's. Oregon series
Ook voor Garmin Colorado 400c: Gebruikershandleiding (48 pagina's), Snelle referentiehandleiding (2 pagina's), Snelstarthandleiding (2 pagina's), Gebruikershandleiding (48 pagina's), Belangrijke veiligheidsinformatie (48 pagina's), Gebruikershandleiding (26 pagina's), (Deens) Handboek (48 pagina's)

Changing the System Settings

To change the system settings, on the Configure screen, highlight

System, and press SElECt.

beeper—set when the unit makes audible sounds. The three settings

are Off, Alarms Only (default), and On (keys and alarms).

Simulator—turn on the Simulator to have the Fishfinder 400C act as

though a transducer is connected.

NMEA Output— connect the Fishfinder 400C to NMEA compatible

electronic equipment (such as a Garmin GPS device) and send

information. To do so, you must change this setting to On. For more

information on connecting to a NMEA device, see

language—select the on-screen language.

System Information—view the current operating software version

and your unit's unique internal unit ID.

Factory Settings—reset the Fishfinder 400C to the factory settings.

You are prompted to confirm your choice to restore all factory

settings. Choose yes. Otherwise, choose No to retain your current

configuration.

Fishfinder 400C Owner's Manual

To change the transducer settings, on the Configure screen, highlight

transducer, and press SElECt.

type—select the transducer type (Dual Frequency or Dual beam).

Keel Offset —offset the surface reading for the depth of a keel so

you can measure depth from the bottom of your keel instead of from

the transducer's location. Enter a positive number to offset for a keel.

You can enter a negative number to compensate for a large vessel

that may draw several feet of water.

Transducer at Surface

page

12.

Transducer at Bottom

Enter (-) negative number to

show depth from the surface.

Enter (+) positive

number to show depth

from the bottom of keel.

of Keel

400c

ustomIzIng the

IshFInder