Garmin ECHOMAP Ultra Series Installatie-instructies
Blader online of download pdf Installatie-instructies voor {categorie_naam} Garmin ECHOMAP Ultra Series. Garmin ECHOMAP Ultra Series 4 pagina's. Marine gps chartplotters
Ook voor Garmin ECHOMAP Ultra Series: Installatie-instructies (4 pagina's)
Pagina afdrukken
ECHOMAP
INSTALLATION
INSTRUCTIONS
Important Safety Information
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
When connecting the power cable, do not remove the in-line
fuse holder. To prevent the possibility of injury or product
damage caused by fire or overheating, the appropriate fuse
must be in place as indicated in the product specifications. In
addition, connecting the power cable without the appropriate
fuse in place voids the product warranty.
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
When drilling or cutting, always check what is on the opposite
side of the surface.
To obtain the best performance and to avoid damage to your
boat, install the device according to these instructions.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation,
contact Garmin
Product Support.
®
Tools Needed
• Drill
• Drill bits
◦ Bail mount: drill bits and screws appropriate for the
surface and hardware
◦ Flush mount: 3.2 mm (
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
• Marine sealant (optional)
Mounting Considerations
You can flush mount the device in the dashboard or bail mount
the device on the dashboard.
When selecting a mounting location, observe these
considerations.
• The mounting location must provide a clear view of the
screen and access to the keys on the device.
February 2020
™
ULTRA
WARNING
CAUTION
NOTICE
1
3
/
in.) and 9.5 mm (
/
in.) drill bits
8
8
• The mounting location must be sturdy enough to support the
device and the mount.
• The cables must be long enough to connect the components
to each other and to power.
• To avoid interference with a magnetic compass, do not install
the device closer to a compass than the compass-safe
distance value listed in the product specifications.
Bail Mounting the Device
If you are mounting the bracket on fiberglass with screws, it is
recommended to use a countersink bit to drill a clearance
counterbore through only the top gel-coat layer. This will help to
avoid cracking in the gel-coat layer when the screws are
tightened.
1
Select the mounting hardware appropriate for your mounting
surface and for the bail-mount bracket.
2
Using the bail-mount bracket
holes
.
3
Using a drill bit appropriate for the mounting hardware, drill
the four pilot holes.
4
Using the selected mounting hardware, secure the bail-mount
bracket to the mounting surface.
5
Place the cradle
into the bail-mount bracket, and tighten
the bail-mount knobs
6
Connect all necessary cables to the cradle
page
2), and spin the locking rings clockwise to lock the
cables to the cradle.
To prevent corrosion of the metal contacts, cover unused
connectors with the attached weather caps.
Flush Mounting the Device
Be careful when cutting the hole to flush mount the device.
There is only a small amount of clearance between the case and
the mounting holes, and cutting the hole too large could
compromise the stability of the device after it is mounted.
Using a metal pry tool such as a screwdriver can damage the
trim caps and the device. Use a plastic pry tool when possible.
You can mount the device in your dashboard using the flush-
mount template and appropriate hardware.
1
Secure the template to the mounting location.
TA-2019/5173
GUID-7EC09750-0897-4743-9159-D226DE691962 v4
NOTICE
as a template, mark the pilot
.
(Connector View,
NOTICE
NOTICE