Garmin Fusion Apollo MS-ERX400 Handleiding voor installatie-instructies - Pagina 4
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Garmin Fusion Apollo MS-ERX400. Garmin Fusion Apollo MS-ERX400 8 pagina's.
Ook voor Garmin Fusion Apollo MS-ERX400: Gebruikershandleiding (20 pagina's)
Pagina afdrukken
MS-ERX400 remote control
Wired network switch or wired network router
Compatible stereo, such as an MS-RA770
Compatible stereo, such as an MS-RA670
Connecting to Power and the Network
1 Route the network/power cable to the stereo or to the network switch or router.
Do not connect the cable to the stereo until after you have connected the power wires to avoid possible
damage to the stereo.
TIP: To avoid running additional wires to the battery, you can connect the power and ground wires from this
remote control to the power and ground wires used by the stereo. The stereo should be connected to power
though the ignition or another manual switch.
2 Connect the red power wire
switch
.
Do not remove the in-line fuse holder
or overheating. Connecting the wire without the appropriate fuse in place voids the product warranty. If you
must extend the wire run, you should relocate the fuse so it is near the power source.
3 Connect the black ground wire
4 Select an option:
• If you are using this device to control one stereo and do not have additional devices on a Fusion PartyBus
network, connect the network connector
• If you have a network on the boat connecting multiple compatible devices, connect the network connector
to an open port on the network switch or router.
4
NOTICE
to the positive (+) battery terminal through the ignition or another manual
WARNING
, to prevent the possibility of injury or product damage caused by fire
to the negative (-) battery terminal.
to the ETHERNET port on the stereo.