Garmin Gladiator TR-1 Gebruikershandleiding - Pagina 22

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garmin Gladiator TR-1. Garmin Gladiator TR-1 36 pagina's. Garmin tr-1 marine autopilot: user guide
Ook voor Garmin Gladiator TR-1: Installatie- en gebruikershandleiding (4 pagina's), Gebruikershandleiding (13 pagina's)

Pagina afdrukken

Garmin Gladiator TR-1 Gebruikershandleiding

Description

Acceleration Limiter

Code 5:

This parameter limits the aggressiveness of the autopilot controlled turns. Turn it up to allow higher rate turns

and down to limit the turn rate.

Seastate Filtering

Code 1:

Seastate adjustments, toward least responsive, slow the heading response down and reduce rudder activity. Most of the

time you will want to run with this parameter all the way at the top of its range. In choppy or trailing seas at low speeds, reducing

this parameter will save wear and tear on your system.

Low Speed Rudder Gain

Low Speed Counter Rudder Gain

High Speed Rudder Gain

High Speed Counter Rudder Gain

Following Seas Switch

Code 159: Turning this parameter on may increase stability in severe trailing seas.

Turn Stop Adjust

Code 268:

At planing speed and for large turn angles; if your boat tends to turn further than you programmed for, (like

50 degrees when you programmed 45 degrees) and then slowly recovers to the turn angle you expected, turning this

parameter up may solve the problem.

Description

Calibrate Compass

Autotune

Load Factory Compass

Load Factory Pilot

Show Software Version

Table of Setup Codes

FINE TUNING CODES

Code

1 lowest accel, 100 Highest accel

1 least responsive steering, 4 most responsive

steering

1 lowest gain 97 highest gain

1 lowest gain, 97 highest gain

1 lowest gain 97 highest

1 lowest gain, 97 highest gain

159

[Up Arrow] on, [Down Arrow] off

268

1 least adjustment, 40 most adjustment

AUTOMATED SETUP CODES

Code

Hold Down [Select Load] Button, Press and Release Deckmount Button

to Start Calibration Process

Hold Down [Select Load] Button, Press and Release Deckmount Button

to Start Tuning Process.

Code 57:

Code 57 lets you select an alternate autotune. You may want to try this

if the normal tune didn't work. After selecting the alternate by selecting code 57 and

pressing the Down Arrow button (so that the Down Arrow LED is lit), go back to code

58 to initiate the autotuner.

247

Hold down [Select Load] button, Press and Release Deckmount Button

to Reload Factory Pilot Settings

248

Hold Down [Select Load] Button, press and release Deckmount Button

to Reload Factory Pilot Settings

369

Hold Down [Select Load] Button, version=blink code/100

Values of the Parameters

Factory

Defaults

off