Garmin GSD 26 Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Garmin GSD 26. Garmin GSD 26 14 pagina's. Professional sonar module
Ook voor Garmin GSD 26: Handleiding voor installatie-instructies (6 pagina's), Handleiding voor installatie-instructies (6 pagina's)

Connecting the Sounder

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury

or product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the

product specifications. In addition, connecting the power cable without the appropriate fuse in place will void

the product warranty.

Do not force a cable into its port. Forcing the cable can damage the pins. If the cable is properly aligned, the

cable should connect easily.

Before you connect the sounder to the network, power, and the transducer, you must mount the sounder

(Mounting the Sounder,

page 2).

1 Route the cables using the appropriate tie wraps, fasteners, and sealant to secure the cables along the route

and through any bulkheads or the deck.

2 Install the locking rings on the marine network and power cables

page 6).

3 Connect the bare-wire end of the power cable to a 12 Vdc power source and to ground.

4 Apply dielectric grease to the end of the power cable.

5 Align the notch on the end of the power cable with the power port on the device, and press the cable into

place.

6 Tighten the locking ring.

7 Repeat steps 4 and 5 for the network cable, and connect the device to a transducer

a Transducer or Sensor,

8 Select an option:

• If your boat is equipped with a GMS 10 network port expander, connect the network cable to an available

port on the GMS 10.

• If your boat is not equipped with a GMS 10 network port expander, connect the network cable directly to

the network port on your chartplotter.

When routing cables through your boat, it may be necessary to drill holes to route the cables. Cable routing

grommets can be used to cover cable installation holes. The grommets do not create a waterproof seal. If

necessary, apply a marine sealant after installation to weatherproof around the grommet and the cable. You can

purchase grommets from your Garmin dealer or directly from Garmin at www.garmin.com.

Connecting the Device to a Transducer or Sensor

You must install cord grip plugs in any unused cord grip to make sure water cannot enter the transducer wiring

block area and damage the sounder.

The terminal blocks are not removable.

GSD 26 Installation Instructions

page 3).

WARNING

NOTICE

(Installing Locking Rings on the Cables,

NOTICE

(Connecting the Device to