Garmin Reactor 40 Kicker Handleiding voor installatie-instructies - Pagina 7
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Garmin Reactor 40 Kicker. Garmin Reactor 40 Kicker 29 pagina's.
Ook voor Garmin Reactor 40 Kicker: Configuratiehandleiding (6 pagina's), Configuratiehandleiding (8 pagina's)
Pagina afdrukken
Mounting the CCU
1 Determine the mounting location.
2 Using the CCU as a template, mark the two pilot hole locations on the mounting surface.
1
3 Using a 3 mm (
/
in.) bit, drill the pilot holes.
8
4 Use the included screws to attach the CCU to the mounting surface.
NOTE: If you use mounting hardware other than the provided screws, the hardware must be quality stainless
or brass material to avoid magnetic interference with the CCU.
Test any mounting hardware with a handheld compass to make sure no magnetic fields are present in the
hardware.
ECU Installation
Mounting the ECU
Before you can mount the ECU, you must select a location and determine the correct mounting hardware
Mounting and Connection Considerations, page
1 Hold the ECU in the intended mounting location and mark the locations of the mounting holes on the
mounting surface, using the ECU as a template.
2 Using a drill bit appropriate for the mounting surface and selected mounting hardware, drill the four holes
through the mounting surface.
3 Secure the ECU to the mounting surface using the selected mounting hardware.
Connecting the ECU to Power
When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or
product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product
specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product
warranty.
You should connect the ECU power cable directly to the boat battery, if possible. Although it is not
recommended, if you connect the power cable to a terminal block or other source, you must connect it through
a 40 A fuse.
If you plan to route the ECU power through a breaker or a switch near the helm, you should consider using an
appropriately sized relay and control wire instead of extending the ECU power cable.
1 Route the connector-terminated end of the ECU power cable to the ECU, but do not connect it to the ECU.
2 Route the bare-wire end of the ECU power cable to the boat battery.
If the wire is not long enough, it can be extended
3 Connect the black wire (-) to the negative (-) terminal of the battery, and connect the red wire (+) to the
positive (+) terminal of the battery.
4 After you install all of the other autopilot components, connect the power cable to the ECU.
You should apply dielectric grease to the pin holes on the cable connector to prevent corrosion, especially if
you are using the autopilot system in saltwater.
5).
WARNING
(Power Cable Extensions, page
NOTICE
(ECU
9).
7