A-Fire Design AWO 60-150 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} A-Fire Design AWO 60-150. A-Fire Design AWO 60-150 11 pagina's.

The ON/OFF button turns the device on and off. Button B1 is used to fill the reservoir with water.

Button B2 is used to empty the device. Hold the button for 5 seconds to start the pumps. Press

once to stop the pumps. The stainless-steel "Tube" connection connects to the plastic hose provided

to fill and empty the device.

ATTENTION: The water used must be perfectly clean with no dust or reside that may clog the

hydraulic system. This point is very important for the operation of your device.

B- Using your device for the first time

Depending on your type of device (PREMIUM AWP, XXL AW, Angle AWA, AW-VIP), it may be

connected directly to your home's water network (see diagram below, ¼" ). In this case, if you press

the ON/OFF button and the isoalation tap on the hydraulic circuit is open, the device will fill

automatically. In all cases, if you do not use your device, shut off the income water supply to

avoid leaking.

If the device is not connected to the water network, you can fill the reservoir using button B1 (fill). To

do so, first, connect the provided hose to the staintless-steel connector (tube) and submerge the mart

of the hose with its filter in a container of water. Then, press the ON/OFF button. The row of orange

LEDs will blink immediately (empty reservoir). Then, press B1 during 5 secondes once and the filling

pump will start and stop automatically when the reservoir is full. The organge LEDs will remain on and

vapor will start to come out of your device. Note: for the first filling, you will need: 2 liters for AWP 20-

50 and AWO2 0-50, 4 liters for AWP 40-100, AWO 40-100, and AWX 40-100, 6.5 liters for AWP 60-

150 and AWX 60-150. Then, you can control your device using the remote control or the App.

If your device is an ORIGINAL AWO, filling is done manually. You will need to remore the top plate to

access the reservoir cap. When filling, be sure not to let the water overflow, and preferabely use a

funnel.

C- Caution:

Tap water may be used in our devices, however, be sure the water is not considered to be "hard"

and that it contains no impurities (may clog valves). If your water is hard, you must use filtered or

softened water in order not to wear out the Mist Maker too quickly.