Fujitsu ABT24RG Bedieningshandleiding - Pagina 5

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Fujitsu ABT24RG. Fujitsu ABT24RG 17 pagina's. Floor console/under ceiling dual type
Ook voor Fujitsu ABT24RG: Bedieningshandleiding (17 pagina's), Bedieningshandleiding (17 pagina's)

Pagina afdrukken

1. Features and Functions

Fig. 1 Indoor Unit

1 Operating Control Panel (Fig. 2)

2 MANUAL AUTO button

3 Remote Control Signal Receiver

4 OPERATION Indicator Lamp (red)

5 TIMER Indicator Lamp (green)

6 SWING Indicator Lamp (orange)

(VERTICAL SWING)

7 SWING Indicator Lamp (orange)

(HORIZONTAL SWING)

If the TIMER indicator lamp flashes when

the timer is operating, it indicates that a

fault has occurred with the timer setting

(See Page 17 Auto Restart).

8 Intake Grille (Fig. 3)

9 Air Filter

0 UP/DOWN Air Direction Flaps

A RIGHT/LEFT Air Direction Louvers

(behind UP/DOWN Air Direction Flaps)

B Drain Hose

C Power Supply Plug

D Power Supply Cord

Fig. 4 Outdoor Unit

E Intake Port

F Outlet Port

G Pipe Unit

Fig. 5 Remote Control Unit

H SLEEP Button

I MASTER CONTROL Button

J SET TEMP./SET TIME Buttons (

K Signal Transmitter

L TIMER Button

M FAN CONTROL Button

N START/STOP Button

O Battery compartment lid

Inside of the battery compartment lid (Fig. 6)

P AIR FLOW DIRECTION Button

Q ENERGY SAVE Button

R CODE CHANGE (Slide Switch)

Switching the remote control unit code.

(Max. 4 units)

S TIME ADJUST Button

T TEST RUN Button

G This button is used when installing the air

conditioner and should not be used under

normal conditions as it will cause the air

conditioner's thermostat function to oper-

ate incorrectly.

G If this button is pressed during normal op-

eration, the unit will switch to test opera-

tion mode, and the indoor unit's OPERA-

TION indicator lamp and TIMER indicator

lamp will begin to flash simultaneously.

G To stop the test operation mode, either

press the TEST RUN button once again, or

press the START/STOP button to stop the

air conditioner.

U ACL Button

V Remote Control Unit Display (Fig. 7)

W Transmit Indicator

X Clock Display

Y Operating Mode Display

Z Timer Mode Display

[ Fan Speed Display

\ Temperature Set Display

] Timer Set Indicator

` Temperature Set Indicator

)