AEG Oko-Favorit 50719 Servicehandleiding - Pagina 32

Blader online of download pdf Servicehandleiding voor {categorie_naam} AEG Oko-Favorit 50719. AEG Oko-Favorit 50719 35 pagina's.

Pagina afdrukken
Failure display
9v†ƒyh ’
Ah vyˆ…r
QQ9ÃÃG@9†
for customer
L D9
Closed water tap
L D10
blinking
L D11
L D9
L D10
Drain pump
blinking
L D11
L D9
Aqua-Control
L D10
blinking
L D11
L D9
L D10
Heating
L D11
L D9
NTC-Sensor
L D10
L D11
L D9
Tacho
L D10
blinking
L D11
L D9
Circulation pump
L D10
Triac short circuit
blinking
L D11
no
Wrong variant
programming
display
Visible in failure
visible
memory
(After sales)
Timeout for filling - Failure recognised if ...
yes
yes
highlighted
3) ... after 1 min of dynamic refilling during heating phase ...
... the switch point of the pressure switch wasnt reached.
yes
yes
Pressure switch didn't reach the switch back after 2 drain cycles.
highlighted
yes
yes
Floating switch detects water in the bottom tray
highlighted
yes
Target temperature not reached after a timeout of 45 min.
no
highlighted
(Only possible in temperature controlled heating steps)
yes
no
The NTC is controlled between the 1st filling and the start of the
highlighted
yes
yes
After activating the circulation pump, within 30 sec no signal from
highlighted
yes
yes
Signal from tachometer is recognised, although the circulation
highlighted
no
no
not possible
Tu‚…‡Ãqr†p…vƒ‡v‚
1) ... after 2 min of static filling ...
2) ... after 4 min of total filling ...
(Debounce time 2sec.)
NTC short circuit or interrupt.
drying cycle
the tachometer is recognised.
pump isn't activated.
Checksum in EEProm not correct.
Only recognised after switching ON.
Xuh‡Ãuh ƒƒr†4
Progr.-LED blinking. Program stopped.
After removing the failure, the program can be continued
bei pressing button S0 (OFF-ON).
Progr.-LED blinking. Program stopped.
After removing the failure, the program can be continued
bei pressing button S0 (OFF-ON).
Program interrupted.
Inlet valve closed and drain pump activated for 1 drain cycle
(approx. 1min).
After removing the failure, the program can be continued
bei pressing button S0 (OFF-ON).
Program is terminated without activation of the heating
element!
All heating steps last 45min in general.
Program is terminated without activation of the heating
element!
All heating steps last 45min in general.
The program is interrupted.
By pressing the button S0 (OFF-ON), the program can be
restarted.
Õ
(Failure repeatedly occuring
Service call)
The program is interrupted and water filled till the switch
oint of the pressure switch.
By pressing the button S0 (OFF-ON), the program can be
restarted.
(Failure repeatedly occuring ð Service call)
No program selection possible
On/Off-lamp (LD0) on