2N Lift1 Compact Beknopte handleiding - Pagina 9
Blader online of download pdf Beknopte handleiding voor {categorie_naam} 2N Lift1 Compact. 2N Lift1 Compact 12 pagina's. For lifts
Ook voor 2N Lift1 Compact: Beknopte handleiding (12 pagina's)
Pagina afdrukken
872 – Message
recording
875 – Message
options
876 – End-of call
message language
selection
877 – Outgoing call
message language
selection
912 – Maximum call
time
913 – Login time limit
(for automatic
dialling)
914 – Delayed call
916 – Cancel input
inversion
920 – Alarm button
mode
962 – Minimum
button pressing time
0–30 s
empty
2 digits
55
0–9
1
0–99
1
15–990 s
120 s
10–990 s
60 s
0–1000 s
0 s
0-1
0
0-2
0
100–9999
100 ms
ms
User announcement recording function,
can be used for lift identification.
1st digit = message that is repeated
after number dialing
2nd digit = message that is played after
connection confirmation and call end
The meanings of the digits are as
follows:
1 = play user message recorded via
parameter 972
2 = read identification – parameter 974
3 = combine options 1 + 2
4 = send identification by DTMF
5 = message as specified in parameter
977 (after confirmation according to
parameter 976)
6 = combine options 5 + 2
7 = confirmation tone (after confirmation
only)
0,3,5,7 =
1 = English (or other main language
depending on Lift1 version)
2 = English (or tones for English
version)
4 = German
6 = Polish
8 = Portugese
9 = Dutch
10 to 99 = silence
Use the call-extending command to
extend the call (DTMF 4 or *).
Set the maximum period of time for the
control centre staff to answer the call
and send confirmation, otherwise Lift1
hangs up and dials the next number.
Counted from the end of dialling.
Applied only if the CANCEL input is
connected.
0 = contact closed or voltage present at
opened door
1 = contact opened or voltage not
present at opened door
0 = normally open contact or voltage
present to activate
1 = normally closed contact or voltage
not present to activate
2 = autodetection, during the next boot
of the device the state of the input
will be set as not active state.
Applies to the ALARM button.
8