AEG 61502 G Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} AEG 61502 G. AEG 61502 G 28 pagina's. Gas hob
Ook voor AEG 61502 G: Gebruiksaanwijzing (28 pagina's)

Pagina afdrukken

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

To light a burner:

push the electric ignition push button which is marked

by a little spark.

At the same time, turn the relevant knob anticlockwise

to maximum position ( ).

Upon ignition, keep the knob pushed down about 5

seconds. This will allow the "thermocouple" (fig. 1 -

letter D) to be heated and the safety device to be

switched off, otherwise the gas supply would be

interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control knob to

zero, and try again.

When switching on the mains, after installation or

a power cut, it is quite normal for the spark

generator to be activated automatically.

In the absence of electricity, ignition is possible without the electrical device; in this

case, use either a match or hand held spark generator specifically designed for this

purpose, push the relevant knob down and turn it anti-clockwise until it reaches the

"maximum" position.

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1