AEG 6562 G Instructie- en installatieboek - Pagina 6

Blader online of download pdf Instructie- en installatieboek voor {categorie_naam} AEG 6562 G. AEG 6562 G 10 pagina's.

Description of the product

Gas burner

Control knob

Air intake

The primary air intake aperture must

never be blocked by objests of any kind

at any time.

Gas installation

The appliance is factory set for Natural

Gas. Fit the gas regulator supplied with

the appliance to the gas inlet. The

location of the gas inlet is

approximately 240mm form the right

hand side of the appliance and

40mm from the back of the appliance.

The connection of the Gas Regulator is

½" Gas female thread and the pressure

at the test point should be adjusted

to1.00kPa with the large and simmer

burners operating at maximum.

For Universal LPG connection, the

appliance needs to be first converted

using the conversion kit and

instructions supplied with the

appliance.

For Universal LPG the regulator is

fitted to the gas inlet of the appliance

so that a pressure test point is available.

The regulator should be disabled by

adjusting the regulator adjusting screw

to be fully screwed in, but do not

remove the locking nut from the

regulator. The supply pressure to the

appliance is controlled by the regulator

located on the LPG cylinder. This

cylinder regulator should be adjusted to

give a pressure of 2.75kPa at the

appliance inlet with the large and

simmer burners operating at maximum.

Typical Adjustment

for Natural Gas

Adjusted for LPG

B2004