Fujitsu RSG36KMTA Bedieningshandleiding - Pagina 11
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Fujitsu RSG36KMTA. Fujitsu RSG36KMTA 16 pagina's.
Pagina afdrukken
Cleaning air filter
1. Open the intake grille until it snaps.
2. Remove the air filters.
Lift up the air filters' handle, disconnect the two lower tabs, and pull
out.
Air filter handle
Tabs (2 places)
3. Remove the dust in either of the following ways.
• Cleaning with vacuum cleaner.
• Washing with mild detergent and warm water. After washing, dry the
air filters thoroughly in shade.
4. Replace the air filters.
Align the sides of the air filter with the panel, and push in fully.
Make sure to the two lower tabs are returned to their holes in the
indoor unit properly.
5. Close the intake grille.
Press 4 places on the intake grille to close it completely.
NOTE: If dirt accumulates on the air filter, airflow will be reduced,
operating efficiency will lower, and the noise will increase.
Cleaning Ion deodorization filter and
Replacing Apple-catechin filter
1. Remove the air filters. Refer to steps 1 ~ 2 of "Cleaning air
filter".
2. Remove the air cleaning filters from the air cleaning filter
holder.
Air cleaning filter
3. Flush the Ion deodorization filter with high-pressure hot
water until the surface of the filters are covered with water.
4. Wash the Ion deodorization filter with diluent neutral
detergent.
Do not ream or rub, otherwise the deodorizing effect may decrease.
5. Rinse the Ion deodorization filter with water flow.
6. Dry the Ion deodorization filter in shade.
7. Set the new or washed air cleaning filters into the air
cleaning filter holders.
NOTE: Use the Apple-catechin filter as soon as possible after opening
the package. The air cleaning effect decreases when the filters
are left in the opened package.
Air cleaning filter holder
8. Install the air cleaning filter holders to the air filters.
Engage the 2 hooks at the rear of the air cleaning filter holder with
the latch at both ends of the air filter.
NOTE: Take care that the air cleaning filter does not project beyond
the holder.
9. Engage the six hooks at the top and bottom of the air
cleaning filter holder with the Latchs of the air filter.
Rear of the filter
Hook and Latch
(6 places)
10. Replace the air filters and close the intake grille. Refer to
steps 4 ~ 5 of "Cleaning air filter".
Replacing Ion deodorization filter
1. Remove the air filters. Refer to steps 1 ~ 2 of "Cleaning air filter".
2. Remove the Ion deodorization filter from the air cleaning
filter holder.
3. Install the new Ion deodorizing filter.
After extended non-use of the unit
If you have shut down the indoor unit for 1 month or more, perform the
Fan mode operation for half a day to dry the internal parts thoroughly
before the normal operation.
Additional inspection
After long period of use, accumulated dust inside the indoor unit may
reduce the performance even if you have maintained the unit properly.
In such a case, a product inspection is recommended.
For more information, consult authorized service personnel.
Filter indicator reset (Special setting)
This function can be used if set correctly during installation. Consult
authorized service personnel in order to use this function.
Clean the air filter when the indicator lamp show the
)
)
following:
Indicator lamp
Blinks 3 times, at intervals of 21 seconds
After cleaning, reset the filter indicator by pushing
indoor unit for 2 seconds or less.
Latch (2 places at the rear)
Hook (2 places)
Blinking pattern
on the
En-10