Fujitsu Lifebook LH531 Bios Handleiding - Pagina 9
Blader online of download pdf Bios Handleiding voor {categorie_naam} Fujitsu Lifebook LH531. Fujitsu Lifebook LH531 14 pagina's. Lifebook l series
Ook voor Fujitsu Lifebook LH531: Snelstarthandleiding (2 pagina's), Gegevensblad (6 pagina's), Aan de slag handleiding (12 pagina's)
Pagina afdrukken
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security features of your notebook to fit operating needs and to view
the current data security configuration. (See Navigating through the Setup Utility on page 2 for more information.)
The following tables show the names of the menu fields for the Security Menu and its submenus, all the options for
each field, the default settings and a description of the field's function and any special information needed to help
understand the field's use. The default condition is no passwords required and no write protection.
Remember your passwords! If you set and forget your User and Master hard disk passwords, Fujitsu
America will not be able to reset it. You may lose data and have to replace your system board or hard disk
drive.
WARNING. VERY IMPORTANT if your hard disk drive is protected using a Full Disk Encryption (FDE)
"engine". FDE encrypts all data as it is written to the hard drive. When data is retrieved from the hard
drive, it is decrypted by the same engine.
FDE, all data and applications on the hard drive will remain encrypted and will effectively be lost.
sure to remember your hard disk password.
Entering a password incorrectly 3 times in a row causes the keyboard and mouse to be locked out and
[System Disabled] to be displayed. If this occurs, restart the computer by turning off and on the power
with the power switch and use the correct password on reboot.
If you make an error when re-entering the password a Warning will be displayed. To try again press
[Enter], then retype the password, or press [Esc] to abort the password process.
If the Password on Boot is Disabled you will not have to type your password upon resuming the system
from the Suspend or Save-to-Disk modes. Power Management Security will work only if Password boot
is enabled.
Info
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Password on Boot:
Hard Disk Security
F1
Help
ESC
Exit
Phoenix SecureCore(tm) Tiano Setup
System
Advanced
Security
Clear
Clear
[Enter]
[Enter]
[Disabled]
Select Item
Select Menu
Figure 5. Security Menu
If you forget your hard disk security password on a system with
Boot
Exit
Change Values
-/Space
Select
Sub-Menu
Enter
S e c u r i t y M e n u
Item Specific Help
Press <Enter> key to
set Supervisor
Password to enable
any password features.
Then password entry is
required to enter BIOS
Setup.
F9
Setup Defaults
F10
Save and Exit
Be
9