Brother P-touch PT-D400 Gebruikershandleiding - Pagina 30

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Brother P-touch PT-D400. Brother P-touch PT-D400 32 pagina's. Electronic label system
Ook voor Brother P-touch PT-D400: Gebruikershandleiding (33 pagina's)

Brother P-touch PT-D400 Gebruikershandleiding

TROUBLESHOOTING

What to do when...

Problem
The screen 'locks',
or the P-touch
labeler does not
respond normally.
The display
remains blank after
turning on the
power.
The LCD messages
are displayed in a
foreign language.
The label is not
printed after
pressing the Print
key.
The label is not
printed correctly.
The ink ribbon is
separated from the
ink roller.
The P-touch labeler
stops while
printing a label.
Label files saved
previously are now
empty.
A tape jam which
cannot be cleared
keeps occurring.
28
What to do when...
1.800.561.8187
• Refer to "Resetting the P-touch Labeler" on page 26
and reset the internal memory to the initial settings. If
resetting the P-touch labeler does not solve the
problem, disconnect the AC adapter and remove the
batteries for more than 10 minutes.
• Check that the batteries are correctly installed and that
the AC adapter designed exclusively for your P-touch
labeler is correctly connected. Check that the
rechargeable battery is fully charged.
• Refer to "Setting Unit and Language" on page 9 to
select your desired language.
• Check that text has been entered and that the tape
cassette is installed correctly with sufficient tape
remaining.
• If the tape is bent, cut off the bent section and thread the
tape through the tape exit slot.
• If the tape is jammed, remove the tape cassette and
then pull out the jammed tape and cut it. Check that the
end of the tape passes through the tape guide before
reinstalling the tape cassette.
• Remove the tape cassette and reinstall it, pressing it
firmly until it clicks into place.
• If the print head is dirty, clean it with a cotton swab or
optional print head cleaning cassette (TZe-CL4).
• If the ink ribbon is broken,
replace the tape cassette. If not,
leave the tape uncut and remove
the tape cassette, then wind the
loose ink ribbon onto the spool as
shown in the figure.
• Replace the tape cassette if striped tape is visible, as
this indicates that you have reached the end of the tape.
• Replace all batteries or connect the AC adapter directly
to the P-touch labeler.
• All files stored in the internal memory are deleted if the
batteries are weak or the AC adapter was disconnected.
• Please contact Brother customer service.
www.
.com
Solution
Spool