Brother TD-2125NWB Gebruikershandleiding - Pagina 37

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Brother TD-2125NWB. Brother TD-2125NWB 38 pagina's.

Appendix B

Using ARP to configure the IP address

If you are unable to use the BRAdmin application and your network does not use a DHCP server, you can

also use the ARP command. The ARP command is available on Windows systems that have TCP/IP

installed. To use ARP enter the following command at the command prompt:

arp -s ipaddress ethernetaddress

ping ipaddress

Where ethernetaddress is the MAC Address/Ethernet Address of the print server and ipaddress is the

IP address of the print server. For example:



Windows systems

Windows systems require the dash "-" character between each digit of the MAC Address/Ethernet Address.

arp -s 192.168.1.2 00-80-77-31-01-07

ping 192.168.1.2

NOTE

You must be on the same Ethernet segment (that is, there cannot be a router between the print server and

operating system) to use the arp -s command.

If there is a router, you may use BOOTP or other methods described in this chapter to enter the IP address.

If your administrator has configured the system to deliver IP addresses using BOOTP, DHCP or RARP your

Brother print server can receive an IP address from any one of these IP address allocation systems. In

which case, you will not need to use the ARP command. The ARP command only works once. For security

reasons, once you have successfully configured the IP address of a Brother print server using the ARP

command, you cannot use the ARP command again to change the address. The print server will ignore any

attempts to do this. If you wish to change the IP address again, use Web Based Management via the web

browser, or factory reset the print server (which will then allow you to use the ARP command again).