Fujitsu BS2000 SE310 Bedieningshandleiding - Pagina 12

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Fujitsu BS2000 SE310. Fujitsu BS2000 SE310 22 pagina's. Server unit x86

2.2.2 Indicators on the operating panel

Indicator

Meaning

ID indicator (blue)

Lights up blue when the Server Unit has been selected by pressing the ID button. To deactivate,

press the button again.

The ID indicator can also be activated via the ServerView Operations Manager and the iRMC web

interface, and its status can be reported to the ServerView Operations Manager and the iRMC.

Status indicator (green)

Does not light up when the Server Unit is switched off but connected to the power supply (power

cable connected).

Lights up green during power up and when operating normally (S0).

Status indicator (power cable connected) (green)

on the right-hand side of the On/Off switch

Does not light up in the following cases:

The Server Unit is not connected to the power source

The Server Unit is switched on and operating normally (S0)

Lights up green when one of the following cases occurs:

The Server Unit is switched off but connected to the power supply (power cable connected)

The Server Unit is switched on but is in the power up delay

After the Server Unit has been connected to the power source, it takes approximately 60

seconds until the Server Unit has entered standby mode.

HDD activity indicator (green)

Lights up green when an internal hard disk drive is being accessed.

Global error indicator (yellow)

Lights up yellow when a prefailure event was detected which requires Customer Support to become

active (by way of precaution).

Flashes yellow when an error was detected which requires Customer Support to become active.

Does not light up when no critical event has occurred.

If the event is still acute after a power failure, the indicator is activated after the restart.

The indicator also lights up in standby mode.

If the indicator flashes or lights up

yellow

, call Customer Support.