Fujitsu SPARC Enterprise T5120 Aan de slag handleiding - Pagina 2
Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Fujitsu SPARC Enterprise T5120. Fujitsu SPARC Enterprise T5120 12 pagina's. Sparc enterprise
Ook voor Fujitsu SPARC Enterprise T5120: Overzicht handleiding (34 pagina's), Aan de slag handleiding (12 pagina's), Handleiding voor locatieplanning (26 pagina's), Veiligheids- en nalevingshandleiding (34 pagina's)
Pagina afdrukken
Choose the best instructions for your situation – The quick setup instructions in this guide work for any
■
networking environment, and require the use of a terminal device for connection to a serial port. If you have
a networking environment running DHCP, you can configure your system using the Ethernet management
port. To take advantage of the DHCP setup method, refer to the online installation guide in the online
product documentation set at: http://www.fujitsu.com/sparcenterprise/manual/
Set aside sufficient time – Installation times vary, but if you are performing these setup instructions for the
■
first time, plan to spend about 45 to 75 minutes to complete all of these instructions. Additional time might be
required for installing optional hardware and rackmounting kits.
Obtain a terminal device – You configure this rackmountable server through the SP using the built-in serial
■
and network management ports, and not through a graphical interface and keyboard. To communicate with
the SP, you will need a terminal device, which can be a terminal, terminal server, or laptop running terminal
emulation software.
Gather your configuration information – During the configuration, you are prompted for time zone and
■
networking parameters for your environment. Use
Configuration Information
TABLE 1
Parameter
Description
Language
Select a number from the displayed language list.
Locale
Select a number from the displayed locale list.
Terminal Type
Select a terminal type that corresponds with your terminal device.
Network?
Select Yes.
Multiple Network
Select the network interfaces that you plan to configure. If you are not sure,
Interfaces
select the first one in the list.
DHCP?
Select Yes or No according to your network environment.
Host Name
Enter the host name for the server.
IP Address
Enter the IP address for the selected Ethernet interfaces.
Subnet?
Select Yes or No according to your network environment.
(If subnet was Yes) Enter the netmask for the subnet for your network
Subnet Netmask
environment.
IPv6?
Specify whether or not to use IPv6. If you are not sure, select No to
configure the Ethernet interface for IPv4.
Security Policy
Select either standard UNIX security (No) or Kerberos Security (Yes). If you
are not sure, select No.
Confirm
Review the onscreen information and change it if needed. Otherwise,
continue.
Name Service
Select the name service according to your network environment.
Note – If you select a name service other than None, you will be prompted
for additional name service configuration information.
Select the type of domain name configuration according to your
NFSv4 Domain
environment. If you are not sure, select Use the NFSv4 domain derived
Name
by the system.
Time Zone
Select your continent.
(Continent)
Time Zone
Select your country or region.
(Country or Region)
to record your configuration information.
TABLE 1
Your Entry