■ Failure to Connect to a Server using its IP Address
If a server cannot be connected to by using its IP address, and does not respond to a ping test, try the following steps:
No.
1
Connection error between a server and the
scanner, or problem with the LAN cable.
2
IP address or subnet mask is invalid.
3
When using DHCP, the DHCP server does
not operate normally, or there is a problem
with the DHCP server settings.
4
Another host or communication device is
connected using the same IP address as
the scanner.
5
Access is denied due to the establishment
of a firewall between the server and the
scanner.
Problem
Check that the LAN cable has been attached to both the scanner
and server correctly.
If the server is connected using a LAN cable (straight type), in
case auto-mdi (automatic selection) is not supported, a LAN
cable (crossover type), switch, or router is required between the
scanner and server.
If this is not the case, the LAN cable may be faulty. Find a
LAN cable that functions normally and try again.
On the "IP Address" screen, check that the IP address or subnet
mask settings are correct.
For more details about the "IP Address" screen, refer to "3.5
Setting the IP Address/DHCP" (page 8).
Check the DHCP server connection status and the details of the
server settings.
If using DHCP, on the "Network Status" screen, check that IP
address, subnet mask, and default gateway settings are all cor-
rect.
If these settings are not correct, the DHCP server may not oper-
ate normally, or the DHCP server may not assign valid IP
addresses because of restricted number of leases or MAC
address validation.
If the DHCP server operating environment is changed, restart
the scanner.
The "Network Status" screen can be displayed as follows:
1.
Select the [Network Settings] tab on the top menu.
2.
Press the [
] button on the left side menu.
3.
Select the [Network Status] tab on the left side menu.
If the same IP address has already been used by another host or
communication device, then even if the other device has been
given a different IP address the server may not recognize the
scanner's "duplicate" IP address until it is rebooted. Restart the
server.
If a duplicate IP address connection from another host or com-
munication device exists on a LAN, both it will be unusable.
If a duplicate IP address connection from another host or com-
munication device exists, pull out its LAN cable and restart the
server.
If a firewall has been established between the server and the
scanner, check that it has not been set to deny access to the net-
work.
25
Action
Pagina afdrukken