Fujitsu ETERNUS DX Disk Configuratiehandleiding - Pagina 18

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 28 pagina's. Server connection, fcoe for linux driver settings for converged network adapter cards
Ook voor Fujitsu ETERNUS DX Disk: Gebruikershandleiding (35 pagina's), Gebruikershandleiding (42 pagina's), Configuratiehandleiding (28 pagina's), Configuratiehandleiding (44 pagina's), Configuratiehandleiding (29 pagina's), Configuratiehandleiding (25 pagina's), Configuratiehandleiding (32 pagina's), Configuratiehandleiding (35 pagina's), Configuratiehandleiding (31 pagina's), Configuratiehandleiding (43 pagina's), Configuratiehandleiding (21 pagina's), Configuratiehandleiding (24 pagina's)

Fujitsu ETERNUS DX Disk Configuratiehandleiding
Chapter 7
Installing the iSCSI Software Initiator and Setting Up the Server
7.2
Setting Up the Server
7.2.2

iSCSI Basic Settings

The following items are required for the iSCSI connection and must be set:
Checking the iSCSI Initiator
Checking the iSCSI Initiator Node Name
Setting the iSCSI Target IP addresses
Enabling the iSCSI Target connection
Creating an iSCSI device link
Checking the ETERNUS DX/AF
1
Check that the iSCSI Initiator service (iscsid) is enabled.
# svcs -a | grep iscsi
disabled
If the iSCSI Initiator service is "disabled" (the default setting), use the "svcadm" command to change it
to the "online" state.
# svcadm enable iscsi/initiator
# svcs -a | grep iscsi
disabled
online
2
Check the iSCSI Initiator Node Name.
Refer to "iSCSI Initiator name" in
3
Set the iSCSI Target IP address(es).
To connect the iSCSI Target, specify the IP address of each iSCSI CA port of the ETERNUS DX/AF that is to
be an iSCSI Target, as a "discovery-address".
# iscsiadm add discovery-address
Enter the IP address for the underlined portion.
Example: CM0Port0: 192.1.1.120, CM1Port0: 192.1.1.121
# iscsiadm add discovery-address 192.1.1.120
# iscsiadm add discovery-address 192.1.1.121
4
Enable the connection to the iSCSI Target.
Enable the connection to the ETERNUS DX/AF that is to be the iSCSI Target.
# iscsiadm modify discovery -t enable
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (iSCSI) for Oracle Solaris
14:30:33 svc:/network/iscsi/initiator:default
14:30:33 svc:/system/iscsitgt:default
14:30:33 svc:/network/iscsi/initiator:default
"Chapter 4 Checking the Server Information" (page
18
Copyright 2017 FUJITSU LIMITED
13).
P3AM-4042-18ENZ0