Fujitsu Eternus DX440 S2 Gebruikershandleiding - Pagina 34
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Fujitsu Eternus DX440 S2. Fujitsu Eternus DX440 S2 42 pagina's. Disk storage system settings
Ook voor Fujitsu Eternus DX440 S2: Gebruikershandleiding (35 pagina's), Installeer setup (20 pagina's), Configuratiehandleiding (28 pagina's), Configuratiehandleiding (15 pagina's)
Pagina afdrukken
Chapter 6
Setting Up the VMware ESX Server
6.2
For VMware Infrastructure 3
6.2.4
Setting the Software Initiator
Enable Software Initiator in VMware ESX.
1
Select the [Configuration] tab on VMware Infrastructure Client and click [Storage Adapters].
2
Select the target iSCSI Software Adapter and click [Properties].
3
Click [Configure] on the [General] tab.
4
Select the [Status-Enabled] checkbox and click the [OK] button.
5
Confirm that the [Enabled] checkbox is selected under "Status" on the [General] tab and click [Config-
ure] again.
6
Confirm that the iSCSI name is displayed as follows and click the [Cancel] button.
7
Select the [Dynamic Discovery] tab and click the [Add] button.
8
Enter the IP address for the iSCSI port of the connected ETERNUS DX Disk storage system as the iSCSI
server IP address, confirm that the port is set to "Port 3260" (default), and click the [OK] button.
ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware
34
Copyright 2013 FUJITSU LIMITED
®
ESX
P3AM-3412-13ENZ0