AEG ProSense 6000 Series Gebruikershandleiding - Pagina 30

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG ProSense 6000 Series. AEG ProSense 6000 Series 40 pagina's.

20°

14.11 Emergency drain

If the appliance cannot drain the water, carry

out the same procedure, described in

'Cleaning the drain pump' paragraph. If

necessary, clean the pump.

14.12 Frost precautions

If the appliance is installed in an area where

the temperature can reach the values around

15. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

15.1 Alarm Codes and Possible failures

The appliance does not start or it stops during operation. First try to find a solution to the problem

(refer to the tables).

WARNING!

Deactivate the appliance before carrying out any check.

With some problems, the display shows an alarm code and the Start/

Pauze button may flash continuously:

Problem

ENGLISH

45°

Possible solution

0° C or drop below, remove the remaining

water from the inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in a

container and let the water flow out of the

hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty, install the

inlet hose again.

WARNING!

Make sure that the temperature is higher

than 0 °C before you use the appliance

again.

The manufacturer is not responsible for

damages caused by low temperatures.