AEG A51100TSW0 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG A51100TSW0. AEG A51100TSW0 36 pagina's.

First use

Temperature regulation

The temperature within the appliance is controlled by the Temperature Regulator situated

on the control panel.

To operate the appliance, proceed as follows:

• turn the Temperature Regulator toward lower settings to obtain the minimum coldness.

• turn the Temperature Regulator toward higher settings to obtain the maximum coldness.

A medium setting is generally the most suitable.

However, the exact setting should be chosen keeping in mind that the temperature inside

the appliance depends on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance.

Fast Freeze function

If more than 3-4 kg of food is to be frozen:

1. Press the Freezer Switch to activate the fast-freeze function 6-24 hours before placing

the fresh food in the freezer, the Yellow Indicator Light will illuminate. The compressor

will now run continuously, to ensure that the fresh food is frozen as quickly as possible.

2. It is possible to deactivate the function at any time by pressing the Freezer Switch.

3. Place the food in the freezing (top) compartment and leave the Freezer Switch on for a

further 24 hours.

4. Then push the Freezer Switch again (the Yellow Indicator Light will go out and the

switch turns to its original position).

5. Move frozen food from the top (freezer) compartment into the other two compart-

ments (storing compartments). For maximum freezing performance remove the top

drawer (if the drawer is foreseen) and then place the foods to be frozen directly on the

evaporator. In case of freezing smaller food volumes you do not need to remove the

drawer.

If the Freezer Switch is accidentally left on, the freezer will not be damaged, but energy will

be wasted.

FIRST USE

Cleaning the interior

Before using the appliance for the first time, wash the interior and all internal accessories

with lukewarm water and some neutral soap so as to remove the typical smell of a brand-

new product, then dry thoroughly.

Do not use detergents or abrasive powders, as these will damage the finish.