Brother 2 Handmatig - Pagina 31
Blader online of download pdf Handmatig voor {categorie_naam} Brother 2. Brother 2 39 pagina's. Hewlett-packard laser printer user guide
Ook voor Brother 2: Gebruikershandleiding (15 pagina's)
Pagina afdrukken
Cutting
Symptom
The material being cut catches
on the tip of the blade.
The machine stopped while an
operation is being performed.
Not all of the material to be cut
is cut. Some areas remain
uncut.
There are deep cuts completely
through the backing paper of
the material.
The material peels off during
cutting.
The material cannot be cleanly
cut.
* For details, refer to the Operation Manual for the cutting machine.
Trimmer blade
Symptom
The material is not being cleanly
cut by the trimmer blade.
The trimmer blade has been
removed from the trimmer.
30
Possible cause (or result)
Lint or dust has accumulated in the holder. Clean the holder.
The blade is worn.
The material being cut is incompatible with
this machine.
For safety, the machine stops operating if a
button in the operation panel is pressed
while cutting.
A blade incompatible with the material is
being used.
If the Cut Pressure setting value is increase
and you are still having issues cutting
evenly, the blade may be chipped.
The blade is worn.
The material is incompatible with this
machine.
The cutting pressure ("Cut Pressure (Half
Cut)") is incorrect.
Lint or dust has accumulated in the holder. Clean the holder.
The cutting pressure ("Cut Pressure (Half
Cut)") is incorrect.
The width of the pattern to be cut is too
narrow, or the size is too small.
"Cut Speed" and "Cut Pressure (Half Cut)"
are not appropriate.
Possible cause (or result)
Before starting to cut, the material and
trimmer were not firmly pressed down with
your hand.
Lint or dust has accumulated in the trimmer
blade.
The trimmer blade is worn.
The trimmer blade was slid past the stopper
on the trimmer.
Solution
Replace the blade with a new one.
Replace the material with one compatible with
this machine.
Follow the instructions in the message that
appears in the screen. Touch the "OK" key to
move the carriage to its initial position. Insert the
material and perform the operation again.
Replace the blade with one compatible with the
material.
Replace the blade with a new one.
Replace the blade with a new one.
Replace the material with one compatible with
this machine.
Adjust the setting for "Cut Pressure (Half Cut)" in
the settings screen.
Adjust the setting for "Cut Pressure (Half Cut)" in
the settings screen.
Increase the width of the pattern, or increase the
size and cut again. The guideline for the width of
the pattern to be cut is 1 mm or more. However,
even at this size, it may not be possible to cut
cleanly depending on the material.
Set "Cut Speed" slower, and "Cut Pressure (Half
Cut)" weaker.
Solution
Firmly press down the material and trimmer with
your hand, and then start cutting.
Clean the trimmer blade.
Replace the trimmer blade with a new one.
Follow the installation instructions to install the
trimmer blade.
Reference
*
*
page 34
page 35
—
*
*
*
page 34
page 35
page 20
*
page 20
—
*
Reference
page 13
page 18
page 28
page 26
page 27