AEG Automatic Refrigerator Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} AEG Automatic Refrigerator. AEG Automatic Refrigerator 11 pagina's. Aeg automatic washing machines
Ook voor AEG Automatic Refrigerator: Gebruiksaanwijzing (10 pagina's), Instructies voor installatie en aansluiting (14 pagina's)
Pagina afdrukken
GB
Commercial use
Should you use your home refrigerator commercial-
ly or for purposes other than refrigeration of food
and drinks, you must observe the legal require-
ments applicable to your area.
Your freezer needs air
Fig.1
The refrigerating unit of your refrigerator is designed
for maintenance-free operation. What it should
never lack is good ventilation. Air is supplied under
the door through the ventilation slot between the
refrigerator and storage surface. Air is extracted
through the upper ventilation grille. Never obstruct
these openings by plinth screens or crockery.
If your refrigerator is installed under a continuous
worktop, an air outlet opening of at least 200 cm
and a ventilation grille (A/B) matching the worktop
design should be provided at the rear of the work-
top (Fig. 1). The cut surfaces of the worktop (C)
should be varnished to avoid swelling due to pene-
tration of moisture.
The appliance wall distance must be at least 30 mm
and should be checked before the ventilation grille
is inserted.
Special accessories:
A = Ventilation grille, brown (E-No. 621 814 002)
B = Ventilation grille, white (E-No. 621 825 004)
Detaching the worktop
Fig. 2
After removal of the worktop of your refrigerator, the
appliance can be installed under a continuous
worktop. To do this, proceed as follows:
Unscrew the Phillips screws (A).
Slide the worktop around 20 mm backwards and lift
upwards (B).
Unscrew the clamping pins (C).
Electrical connection
WARNING - THIS APPLIANCE MUST BE
EARTHED
Please ensure that the voltage and current indicated
on the rating plate agrees with the voltage of your
electricity supply.
220/240 volts ~ (i. e., 220/240 V AC).
If your appliance has been equipped with a mains
12
lead with a moulded-on type plug, you must comply
with the following regulations: The plug moulded on
to the cord incorporates a fuse. For replacement,
use a 13 amp BS 1362 fuse. Only ASTA approved
or certified fuses should be used. The fuse cover/
carrier must be replaced in the event of changing
the fuse. The plug must not be used if the fuse cov-
er/carrier is lost. A replacement cover/carrier must
be obtained from an electrical goods retailer. If the
socket outlets in your home are not suitable for the
plug fitted to the appliance, then the plug must be
cut off and an appropriate one fitted. When fitting
the plug please note the following points:
Important
The wires in the mains lead are coloured in accord-
ance with the following code:
Green and Yellow
2
Blue
Brown
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, pro-
ceed as follows:
1. The wire which is coloured GREEN and YEL-
LOW must be connected to the EARTH termi-
nal in your plug, which is marked with the letter
E or by the earth symbol
GREEN, or GREEN and YELLOW.
2. The wire which is coloured BROWN must be
connected to the LIVE terminal which is marked
with the letter L or coloured RED.
3. The wire which is coloured BLUE must be con-
nected to the neutral terminal which is marked
with the letter N or coloured BLACK.
When wiring the plug, ensure that all strands of wire
are securely retained in each terminal. Do not forget
to tighten the mains lead clamp on the plug.
Warning! A cut off plug inserted into a 13 amp
socket is a serious shock hazard. Ensure that
the cut off plug is disposed of safely.
Voltage
Fuse rating
See rating plate for further information.
The rating plate is located inside the appliance.
Earth
Neutral
Live
220/240 V AC
13 amps
or coloured