Fujitsu SCANPARTNER 600C Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Fujitsu SCANPARTNER 600C. Fujitsu SCANPARTNER 600C 25 pagina's. Image scanner
Ook voor Fujitsu SCANPARTNER 600C: Instructies voor vervanging en reiniging van verbruiksartikelen (7 pagina's), Installatieprocedures (5 pagina's), Gebruikershandleiding (23 pagina's)

terminator connector. The purpose of the terminator is to tell

the controller that there are no more devices on the chain and

that it should not look beyond this device for another device.

Most (but not all) SCSI devices are equipped with 2 SCSI

connectors: one for the connection cable and one to chain or

terminate. Regardless of the methods used, each end of the

chain must be terminated.

In most cases, the controller itself provides termination at one

end of the chain. Termination at the other end must be

provided by the last device on the chain.

Figure 1-5 shows a typical SCSI chain.

Host computer

Terminator

with SCSI

Contoller

Figure 1-5 Typical SCSI Chain

Installing the SCSI Controller

For information on installing the SCSI controller, follow the

instructions provided with the controller.

Setting the SCSI Device ID

When you have several devices on a SCSI chain you may need

to adjust the SCSI ID selector setting located on the back of the

scanner. This setting assigns a specific "device ID" to the

scanner. If the assignment conflicts with an existing SCSI

device, please select a new ID. (See Figure 1-6)

Note: The factory setting for ScanPartner 600C is ID 6. Usually,

ID 0 is assigned to an internal hard disk drive, and ID 7 is

assigned to the SCSI host adapter. ID 8 and 9 are not used.

SCSI Device

1-7

Terminator

SCSI Device