The viewing angle of the mini-dock can be adjusted
to four different positions. The bottom of the support
bail on the rear of the support platform (see Figure
3). snaps into one of four slots. When storing the
mini-dock, flip the bail up against the back of the
support platform to allow the platform to lie flat.
Figure 2. Right Side of Mini-Dock
Support
Bail
Parallel
Port
Serial Port
Video Port
Figure 3. Rear and Left-Side of Mini-Dock
8/00
AC Adapter
Port
PS/2-style
LAN Port
Mouse Port
Support
Platform
PS/2-style
Keyboard
Port
USB
Floppy Disk
Port
Drive Port
Fujitsu is a registered trademark of Fujitsu Ltd. © 2000 Fujitsu PC Corporation
Page 2 of 2
Installing the System into the Mini-Dock
Cautions
• Dropping conductive material onto the charging contacts
could result in internal damage to the pen tablet circuitry.
• Prior to installing your pen tablet into the mini-dock, be
sure to power down your system first. Failure to do so
could result in damage to the system or the mini-dock.
1. Shut down the system by selecting Start> Shut
Down> Shut Down.
2. Position the pen tablet against the positioning
guide and the back of the mini-dock.
3. Slide the pen tablet into the tray at the bottom of
the mini-dock and press it down firmly until it is
seated, as shown in Figure 4. The alignment guide
in the bottom of the tray ensures that the system is
properly seated over the connector.
4. Re-start your system.
Positioning
Guide
Mini-Dock
Base
Figure 4. Installing the System in the Mini-Dock
Removing the System from the Mini-Dock
1. Shut down the system by selecting Start> Shut
Down> Shut Down.
2. While holding the base of the mini-dock with one
hand, grasp the pen tablet at the top and firmly pull
it straight up from the base.
3. Restart your system.
0
Pen Tablet
Mini-Dock
0
58-0737-00B
Pagina afdrukken