Fujitsu D1031 Technisch handboek - Pagina 10

Blader online of download pdf Technisch handboek voor {categorie_naam} Fujitsu D1031. Fujitsu D1031 23 pagina's.

Pagina afdrukken
Introduction
The shipped version of this board complies with the requirements of the EEC
directive 89/336/EEC "Electromagnetic compatibility".
Compliance was tested in a typical PC configuration.
When installing the board, refer to the specific installation information in the
Operating Manual or Technical Manual of the receiving device.
Connecting cables for peripherals must be adequately insulated to avoid interference.
Components can become very hot during operation. Make sure you do not touch
!
components when making extensions to the system board. There is a danger of burns!
The warranty is invalidated if the device is damaged during the installation or
i
replacement of system expansions. Information on which system expansions you can
use is available from your sales outlet or the customer service center.

Information on boards

To prevent damage to the system board or the components and conductors on it, please take great
care when you insert or remove boards. Take care above all to ensure that extension boards are
slotted in straight without damaging components or conductors on the system board, or any other
components, for example EMI spring contacts.
Be especially careful with the locking mechanisms (catches, centering pins etc.) when you replace
the system board or components on it, for example memory modules or processors.
Never use sharp objects (screwdrivers) for leverage.
2 - English
Boards with electrostatic sensitive devices (ESD) are identifiable by the
label shown.
When you handle boards fitted with ESDs, you must observe the following
points under all circumstances:
•
You must always discharge yourself (e.g. by touching a grounded
object) before working.
•
The equipment and tools you use must be free of static charges.
•
Pull out the power plug before inserting or pulling out boards containing
ESDs.
•
Always hold boards with ESDs by their edges.
•
Never touch pins or conductors on boards fitted with ESDs.
A26361-D1031-Z120-10-7419