Fujitsu GA-8I848FS P4 Titan Series Gebruikershandleiding - Pagina 19
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Fujitsu GA-8I848FS P4 Titan Series. Fujitsu GA-8I848FS P4 Titan Series 45 pagina's. P4 titan series motherboard
Pagina afdrukken
7) BATTERY
8) F_PANEL (2 x 10 pins Connector)
Please connect the power LED, PC speaker, reset switch and power switch etc of your chassisfront
panel to the F_PANEL connector according to the pin assignment below.
HD (IDE Hard Disk Active LED)
SPEAK (Speaker Connector)
RES (Reset Switch)
PW (Power Switch)
MSG(Message LED/ Power/ Sleep LED)
NC
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
If you want to erase CMOS...
1. Turn OFF the computer and unplug the power cord.
2. Remove the battery, wait for 30 second.
3. Re-install the battery.
4. Plug the power cord and turn ON the computer.
Message LED/Power/
Sleep LED
MSG-
MSG+
2
1
HD+
IDE Hard Disk
HD-
Active LED
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Open: Normal Operation
Close: Power On/Off
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
NC
- 19 -
Hardware Installation Process
Power
Speaker
Switch
Connector
PW-
SPEAK-
SPEAK+
PW+
1
1
1
20
1
1
19
NC
RES-
RES+
Reset Switch